Infiniti M35/M45 Y50. Manual — part 775
FUEL TANK
FL-11
C
D
E
F
G
H
I
J
K
L
M
A
FL
7.
Disconnect fuel filler hose, vent hose and EVAP hoses at fuel
tank side.
8.
Support the lower part of fuel tank with transmission jack.
CAUTION:
Support the position that fuel tank mounting bands do not
engage.
9.
Remove fuel tank mounting bands.
10. Supporting with hands, descend transmission jack carefully, and remove fuel tank.
CAUTION:
●
Make sure that all connection points have been disconnected.
●
Confirm there is no interference with vehicle.
11. Remove fuel filler tube, as necessary.
INSTALLATION
Note the following, and install in the reverse order of removal.
●
Surely clamp fuel hoses and insert hose to the length below.
●
Be sure hose clamp is not placed on swelled area of fuel tube.
●
Tighten the clamp hand with the top mark until the mark is on the
bolt head flange “A”.
●
To connect quick connector, refer to
INSPECTION AFTER INSTALLATION
Use the following procedure to check for fuel leaks.
1.
Turn ignition switch “ON” (with engine stopped), and check connections for leakage by applying fuel pres-
sure to fuel piping.
PBIC1581E
PBIC0878E
Fuel filler hose
: 35 mm (1.38 in)
The other hoses
: 25 mm (0.98 in)
PBIC3388E
FL-12
FUEL TANK
2.
Start engine and rev it up and make sure there are no fuel leaks at the fuel system tube and hose connec-
tions.
●
After removing/installing rear suspension assembly, make sure to adjust wheel alignment and then, adjust
neutral position of steering angle sensor. Refer to
RSU-5, "Wheel Alignment Inspection"
and
SERVICE DATA AND SPECIFICATIONS (SDS)
FL-13
C
D
E
F
G
H
I
J
K
L
M
A
FL
SERVICE DATA AND SPECIFICATIONS (SDS)
PFP:00030
Standard and Limit
NBS005RG
FUEL TANK
Fuel tank capacity
Approx. 76
(20-1/8 US gal, 16-3/4 Imp gal)
Fuel recommendation
Refer to
FL-14
SERVICE DATA AND SPECIFICATIONS (SDS)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст