Acura RL (1996-2004 year). Manual — part 447
![](/vehicles/shign/ecital/fofa/yor.png)
Rear Cover/Reverse Idler Gear
Disassembly/lnspection/Reassembly
NOTE:
• Inspect the needle bearings for galling and rough movement.
• Coat all parts with ATF before reassembly.
DOWEL PIN
REVERSE IDLER GEAR
SHAFT
THRUST WASHER,
14 x 25 mm
REAR COVER
8 x 1.25 mm
26 N-m
(2.7 kgf-m, 20 Ibf-ft)
REVERSE IDLER GEAR
SHAFT HOLDER
REVERSE IDLER GEAR
Install in this direction.
THRUST WASHER,
14 x 30 mm
Main Menu
Table of Contents
![](/vehicles/shign/ecital/fofa/pareethe.png)
Mainshaft
Disassembly/Inspection/Reassembly
NOTE:
• Lubricate all parts with ATF during reassembly.
• Inspect the thrust needle bearings and the needle bearings for galling and rough movement.
• Before installing the O-rings, wrap the shaft splines with tape to prevent damage to the O-rings.
Install the sealing ring with the
mating faces as shown.
Main Menu
Table of Contents
![](/vehicles/shign/ecital/fofa/anezake.png)
Mainshaft 3rd Gear Removal
1. Remove the
3rd gear, 4th gear, and
thrust washer, 43 x 74 mm from the mainshaft
using the special tool and a press as shown.
PRESS
COLLAR
MAINSHAFT
4TH GEAR
ATTACHMENT,
45 x 55 mm
THRUST WASHER,
43 x 74 mm
4TH GEAR
3RD GEAR
ATTACHMENT,
45 x 55 mm I.D.
Main Menu
Table of Contents
![](/vehicles/shign/ecital/fofa/cay.png)
Inspection
NOTE:
• Inspect and adjust the 43 x 74 mm thrust washer when
disassembling the mainshaft assembly or replacing
mainshaft 3rd gear and/or 1st/4th clutch assembly.
• Lubricate all parts with ATF during assembly.
1. Install mainshaft 3rd gear on the mainshaft using
the special tool and a press as shown.
PRESS
COLLAR
MAINSHAFT
3RD GEAR
ATTACHMENT,
45 x 55 mm 1.0.
3RD GEAR
ATTACHMENT,
45 x 55 mm I.D.
(cont'd)
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст