Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 722
SL-37
Rear Gate Latch and Actuator Assembly
SECURITY AND LOCKS
12.Rear Gate Latch and Actuator
Assembly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear gate trim. <Ref. to EI-69, RE-
3) Remove the bolt.
4) Disconnect the harness connector, and remove
the rear gate latch and actuator assembly.
B: INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to SL-3, REAR GATE LOCK AND
TRUNK LID, COMPONENT, General Descrip-
C: INSPECTION
1. REAR GATE LATCH
Check if the rear gate latch operates normally.
• If latch deformation, abnormal wear, or un-
smooth lock operation is observed, replace the rear
gate latch & actuator assembly.
2. LOCK ACTUATOR
1) Disconnect the connector of rear gate latch and
actuator assembly.
2) Connect the battery to the lock actuator termi-
nals.
3) If the actuator does not operate normally, re-
place the rear gate latch & actuator assembly.
SL-00805
Actuator operation
Terminals
No. 1
No. 2
Lock → Unlock
+
–
SL-00745
4 3 2 1
SL-38
Trunk Lid Latch and Actuator Assembly
SECURITY AND LOCKS
13.Trunk Lid Latch and Actuator
Assembly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the harness connector to remove the
trunk opener cable.
3) Remove the bolts, and remove the trunk lid latch
& actuator assembly.
B: INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to SL-3, REAR GATE LOCK AND
TRUNK LID, COMPONENT, General Descrip-
NOTE:
Apply grease to the movable part.
C: INSPECTION
1. TRUNK LID LATCH
Check if the trunk lid latch operates normally.
• If latch deformation, abnormal wear, or un-
smooth lock operation is observed, replace the rear
gate latch & actuator assembly.
2. LOCK ACTUATOR
1) Disconnect the connector of trunk lid latch and
actuator assembly.
2) Connect the battery to the lock actuator termi-
nals.
3) If the actuator does not operate normally, re-
place the trunk lid latch & actuator assembly
SL-01027
Actuator operation
Terminals
No. 1
No. 2
Lock → Unlock
–
+
SL-00255
3 2 1
SL-39
Front Hood Lock Assembly
SECURITY AND LOCKS
14.Front Hood Lock Assembly
A: REMOVAL
1) Open the front hood.
2) Remove the front bumper face. <Ref. to EI-31,
FRONT BUMPER FACE, REMOVAL, Front
3) Remove the bolts, and then detach the front
hood lock assembly.
4) Remove the release cable from the lock assem-
bly.
B: INSTALLATION
1) Install each part in the reverse order of removal.
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to SL-4, FRONT HOOD LOCK
AND REMOTE OPENERS, COMPONENT,
NOTE:
Apply grease to the movable part.
2) Adjust the fog light beam. (Model with fog light)
<Ref. to LI-21, FOG LIGHT AIMING, ADJUST-
MENT, Front Fog Light Assembly.>
C: ADJUSTMENT
1) Loosen the bolt, and adjust the lock assembly
while moving it up and down.
2) After adjustment, tighten the bolts securely.
D: INSPECTION
Check if the front hood lock assembly operates nor-
mally.
• If latch deformation, abnormal wear, or un-
smooth lock operation is observed, replace the
front hood lock assembly.
SL-00829
SL-00830
SL-40
Remote Openers
SECURITY AND LOCKS
15.Remote Openers
A: REMOVAL
1. FRONT HOOD OPENER
1) Remove the cable from the front hood lock.
2) Remove the bolt, and then detach the opener le-
ver.
2. TRUNK LID OPENER
1) Remove the rear seat. <Ref. to SE-13, REMOV-
2) Remove the lower inner trim, rear quarter trim
and floor mat on the driver’s side. Remove the clip
holding the cable.
3) Remove the opener lever and detach the cover.
4) Remove the bolt and nut, and then detach the
pull handle assembly.
5) Remove the cable from pull handle assembly.
6) Remove the trunk lid latch & actuator assembly
from the trunk lid. <Ref. to SL-38, REMOVAL,
Trunk Lid Latch and Actuator Assembly.>
7) Remove the cable from the trunk lid latch & ac-
tuator assembly.
SL-00832
(1) Opener lever
(2) Pin
(3) Front cover
(4) Pull handle ASSY
(5) Cable
(6) Clamp
(7) Key cylinder
(1) Trunk lid latch and actuator ASSY
(2) Cable
SL-01367
(6)
(3)
(2)
(1)
(4)
(7)
(5)
SL-00385
(1)
(2)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст