Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 676
LI-27
Rear Turn Signal Light Bulb
LIGHTING SYSTEM
21.Rear Turn Signal Light Bulb
A: REMOVAL
1. 4 DOOR MODEL
1) Disconnect the ground cable from battery.
2) Remove the trunk room side trim cover. <Ref. to
EI-63, REMOVAL, Trunk Room Trim.>
3) Turn the socket and remove the bulb.
2. 5 DOOR MODEL
1) Remove the rear combination light assembly.
<Ref. to LI-25, 5 DOOR MODEL, REMOVAL, Rear
2) Turn the socket and remove the bulb.
B: INSTALLATION
Install each part in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) Replace the bulb if it is found defective.
LI-00836
LI-00818
LI-28
Rear Side Marker Light Bulb
LIGHTING SYSTEM
22.Rear Side Marker Light Bulb
A: REMOVAL
NOTE:
Equipped with 5 door model only.
1) Remove the rear combination light assembly.
<Ref. to LI-25, 5 DOOR MODEL, REMOVAL, Rear
2) Turn the socket and remove the bulb.
B: INSTALLATION
Install each part in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) Replace the bulb if it is found defective.
LI-01272
LI-29
Rear Finisher Light Assembly
LIGHTING SYSTEM
23.Rear Finisher Light Assembly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear gate trim. <Ref. to EI-69, RE-
3) Disconnect the rear finisher light connector.
4) Remove the nuts, and then remove the rear fin-
isher light assembly.
B: INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
4.5 N·m (0.46 kgf-m, 3.3 ft-lb)
LI-00819
LI-30
Back-up Light Bulb
LIGHTING SYSTEM
24.Back-up Light Bulb
A: REMOVAL
1. 4 DOOR MODEL
1) Disconnect the ground cable from battery.
2) Remove the trunk room side trim cover. <Ref. to
EI-63, REMOVAL, Trunk Room Trim.>
3) Turn the socket and remove the bulb.
2. 5 DOOR MODEL
1) Disconnect the ground cable from battery.
2) Remove the bulb inspection cover of the rear
gate trim.
3) Turn the socket and remove the bulb.
B: INSTALLATION
Install each part in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) Replace the bulb if it is found defective.
LI-00837
LI-00820
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст