Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 674
LI-19
Front Turn Signal Light Bulb
LIGHTING SYSTEM
14.Front Turn Signal Light Bulb
A: REMOVAL
1) When removing the turn signal light bulb, fully
turn the steering wheels to opposite direction from
the turn signal light bulb to remove.
2) Disconnect the ground cable from battery.
3) Turn the mud guard inward.
4) Turn socket (A) from the wheel arch, and re-
move the front turn signal light bulb.
B: INSTALLATION
Install each part in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) Replace the bulb if it is found defective.
(A)
LI-00832
LI-20
Front Side Marker Light Bulb
LIGHTING SYSTEM
15.Front Side Marker Light Bulb
A: REMOVAL
1) When removing the front side marker light bulb,
fully turn the steering wheel in the opposite direc-
tion from the front side marker light bulb to be re-
moved.
2) Disconnect the ground cable from battery.
3) Turn the mud guard inward.
4) Turn socket (A) from the wheel arch, and re-
move the front side marker light bulb.
B: INSTALLATION
Install each part in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) Replace the bulb if it is found defective.
(A)
LI-00832
LI-21
Front Fog Light Assembly
LIGHTING SYSTEM
16.Front Fog Light Assembly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the screw and clips, and turn over the
mud guard.
3) Disconnect the bulb connector.
4) Remove the bolts, then remove the fog light as-
sembly.
NOTE:
Remove the bracket as required.
B: INSTALLATION
1) Install each part in the reverse order of removal.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
2) Adjust the fog light beam. <Ref. to LI-21, FOG
LIGHT AIMING, ADJUSTMENT, Front Fog Light
C: ADJUSTMENT
1. FOG LIGHT AIMING
1) Before checking the fog light beam level, be sure
of the following:
• The area around the fog light has not sustained
any accident, damage or other type of deformation.
• Vehicle is parked on a level surface.
• The inflation pressure of tires is correct.
• Vehicle’s fuel tank is fully filled.
2) Bounce the vehicle several times to normalize
the suspension.
3) Make certain that someone is seated in the driv-
er’s seat.
4) Remove the clips and turn over the mud guard.
LI-01135
LI-01125
LI-01149
LI-01139
LI-22
Front Fog Light Assembly
LIGHTING SYSTEM
5) Adjust the front fog light pattern by inserting a
Philips screwdriver to the adjusting hole (1).
(A) Vehicle center
(B) Bulb center marking
(C) 3 m (10 ft)
(D) Height of fog light center
h mm (in) at 3 m (10 ft)
60 (2.38)
LI-01126
(1)
LI-00925
(A)
(C)
(B)
h
(D)
(A)
h (D)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст