Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 678
LI-35
Luggage Room Light
LIGHTING SYSTEM
29.Luggage Room Light
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Insert a flat tip screwdriver into the edge of the
luggage room light body to remove the luggage
room light.
3) Disconnect the harness connector and remove
the luggage room light.
4) Remove bulb (A).
B: INSTALLATION
Install each part in the reverse order of removal.
C: INSPECTION
1. LUGGAGE ROOM LIGHT BULB
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) Replace the bulb if it is found defective.
2. LUGGAGE ROOM LIGHT SWITCH
1) Remove the luggage room light.
2) Measure the resistance between luggage room
light switch terminals.
3) Replace the luggage room light if the inspection
result is not within the standard value.
LI-00823
LI-01141
(A)
Switch position
Terminal No.
Standard value
OFF
1 and 2
1 MΩ or more
ON
Less than 1 Ω
LI-00363
2 1
LI-36
Trunk Room Light
LIGHTING SYSTEM
30.Trunk Room Light
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Turn the trunk room light counterclockwise 60°
to remove it and disconnect the harness connector.
3) Remove bulb (A).
B: INSTALLATION
Install each part in the reverse order of removal.
C: INSPECTION
1. TRUNK ROOM LIGHT BULB
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) Replace the bulb if it is found defective.
LI-00321
LI-00286
(A)
LI-37
Ignition Switch Illumination
LIGHTING SYSTEM
31.Ignition Switch Illumination
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the screws and remove the steering
column cover lower.
3) Remove the harness cover lock.
4) Remove the screws and detach the knee protec-
tor.
5) Remove the screws and remove the steering
column cover upper.
6) Remove the instrument panel lower cover. <Ref.
to EI-49, REMOVAL, Instrument Panel Lower Cov-
7) Disconnect the ignition switch illumination con-
nector (A).
8) Turn the ignition switch illumination connector to
the left and remove it.
B: INSTALLATION
Install each part in the reverse order of removal.
WW-00547
LI-01143
LI-01144
(A) Ignition switch illumination connector
(B) Ignition switch illumination
(C) Immobilizer antenna connector
LI-00343
(C)
(B)
(A)
LI-38
Ignition Switch Illumination
LIGHTING SYSTEM
C: INSPECTION
Step
Check
Yes
No
1
CHECK THE IGNITION SWITCH ILLUMINA-
TION.
Make sure the ignition switch illumination illumi-
nates when driver’s side door is open.
Does the ignition switch illumi-
nation illuminate?
Ignition switch illu-
mination is normal.
2
CHECK THE IGNITION SWITCH ILLUMINA-
TION.
Make sure the ignition switch illumination blinks
when the ignition switch is turned to ON.
Does the ignition switch illumi-
nation blink?
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст