Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 679
LI-39
Day Time Running Resistor
LIGHTING SYSTEM
32.Day Time Running Resistor
A: REMOVAL
1) Remove the front bumper face. <Ref. to EI-31,
FRONT BUMPER FACE, REMOVAL, Front
2) Disconnect the harness connector.
3) Remove the bolt, and remove the daytime run-
ning resistor.
B: INSTALLATION
1) Install each part in the reverse order of removal.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
2) Adjust the fog light beam. (Model with fog light)
<Ref. to LI-21, FOG LIGHT AIMING, ADJUST-
MENT, Front Fog Light Assembly.>
LI-00889
LI-40
Reflex Reflector
LIGHTING SYSTEM
33.Reflex Reflector
A: REMOVAL
Remove the reflex reflector by pressing the claw of
the reflex reflector from the backside of bumper.
B: INSTALLATION
Install each part in the reverse order of removal.
LI-00826
LI-41
Door Switch
LIGHTING SYSTEM
34.Door Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the screw, and pull out the door switch.
3) Disconnect the harness connector and remove
the door switch.
B: INSTALLATION
Install each part in the reverse order of removal.
C: INSPECTION
Refer to the door switch inspection of the room light
system. <Ref. to LI-10, DOOR SWITCH, INSPEC-
LI-00827
LI-42
Door Switch
LIGHTING SYSTEM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст