Subaru Legacy III (2000-2003 year). Service manual — part 923
LI-26
LIGHTING SYSTEM
REAR TURN SIGNAL LIGHT BULB
22.Rear Turn Signal Light Bulb
A: REMOVAL
1. SEDAN
1) Open trunk lid and remove cover.
2) Turn the socket and remove the bulb.
2. WAGON
1) Remove rear combination light assembly. <Ref.
to LI-22, WAGON, REMOVAL, Rear Combination
Light Assembly.>
2) Remove the light cover mounting screws then
detach the cover.
3) Turn the socket and remove the bulb.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATIONS, General Description.>
3) If NG, replace the bulb with a new one.
LI-00104
LI-00105
LI-27
LIGHTING SYSTEM
REAR FOG LIGHT BULB
23.Rear Fog Light Bulb
A: REMOVAL
1. SEDAN
1) Open trunk lid and remove cover.
2) Turn the socket and remove the bulb.
2. WAGON
1) Open rear gate lower trim cover.
2) Turn the socket and remove the bulb.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
Specifications.>
3) If NG, replace the bulb with a new one.
LI-00099
LI-00101
LI-28
LIGHTING SYSTEM
LICENSE PLATE LIGHT
24.License Plate Light
A: REMOVAL
1) Remove license plate light mounting screw (A)
and then remove the lens (B)
SEDAN
WAGON
2) Remove the bulb.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATIONS, General Description.>
3) If NG, replace the bulb with a new one.
LI-00106
( A )
( B )
LI-00107
( B )
( A )
LI-29
LIGHTING SYSTEM
HIGH-MOUNTED STOP LIGHT
25.High-mounted Stop Light
A: REMOVAL
1. SEDAN
1) Disconnect ground cable from battery.
2) Disconnect connector of high-mounted stop light
from body harness.
3) Remove bolts, then detach high-mounted stop
light assembly.
2. WAGON
1) Disconnect ground cable from battery.
2) Remove cap (a) by prying on the edge with a
screwdriver.
3) Remove screws (b) and then detach cover (c).
4) Remove screws (d) and then detach high-
mounted stop light while disconnecting connector.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATIONS, General Description.>
3) If NG, replace the bulb with a new one.
LI-00108
LI-00036
( a )
( b )
( c )
( d )
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст