Subaru Legacy III (2000-2003 year). Service manual — part 922
LI-22
LIGHTING SYSTEM
REAR COMBINATION LIGHT ASSEMBLY
18.Rear Combination Light As-
sembly
A: REMOVAL
1. SEDAN
1) Disconnect ground cable from battery.
2) Remove clips and then detach trunk rear trim.
3) Remove hook (A) and then turn over the trunk
side trim of rear portion.
4) Remove harness clip (A).
5) Remove three nuts and then detach rear combi-
nation light while disconnecting connector.
2. WAGON
1) Disconnect ground cable from battery.
2) Remove two rear quarter trim covers.
3) Remove two nuts and then remove rear combi-
nation light while disconnecting connector.
NOTE:
Before removing the nuts, apply a few turns of butyl
tape to the tip of the service tool. This prevents the
nuts from falling during removal.
B: INSTALLATION
Install in the reverse order of removal.
LI-00091
LI-00092
( A )
LI-00093
LI-00094
LI-23
LIGHTING SYSTEM
REAR FINISHER LIGHT ASSEMBLY
19.Rear Finisher Light Assembly
A: REMOVAL
1. SEDAN
1) Disconnect ground cable from battery.
2) Open the trunk lid.
3) Remove cover (A).
4) Disconnect connector (B) from rear finisher light.
5) Remove ten nuts and then detach rear finisher
light from trunk lid.
2. WAGON
1) Disconnect ground cable from battery.
2) Remove rear gate trim (A). <Ref. to EI-44, RE-
MOVAL, Rear Gate Trim.>
3) Disconnect connector from rear finisher light.
4) Remove nuts (A) and then remove rear finisher
light from rear gate.
B: INSTALLATION
Install in the reverse order of removal.
LI-00095
( A )
( B )
( B )
LI-00096
( A )
LI-00097
( A )
( A )
LI-24
LIGHTING SYSTEM
BRAKE/TAIL LIGHT BULB
20.Brake/Tail Light Bulb
A: REMOVAL
1. SEDAN
1) Open trunk lid and remove cover.
2) Turn the socket and remove the bulb.
2. WAGON
1) Remove rear combination light assembly. <Ref.
to LI-22, WAGON, REMOVAL, Rear Combination
Light Assembly.>
2) Turn the socket and remove the bulb.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATIONS, General Description.>
3) If NG, replace the bulb with a new one.
LI-00098
LI-00100
LI-25
LIGHTING SYSTEM
BACK-UP LIGHT BULB
21.Back-up Light Bulb
A: REMOVAL
1. SEDAN
1) Open trunk lid and remove cover.
2) Turn the socket and remove the bulb.
2. WAGON
1) Open rear gate lower trim cover.
2) Turn the socket and remove the bulb.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATIONS, General Description.>
3) If NG, replace the bulb with a new one.
LI-00102
LI-00103
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст