Subaru Legacy III (2000-2003 year). Service manual — part 981
EI-26
EXTERIOR/INTERIOR TRIM
PROTECTOR
B: INSTALLATION
1) Apply primer to original side protector (if used),
and attach two-sided tape to side protectors as
shown.
Two-sided tape:
Thickness; 1.2 mm (0.047 in)
Width; 5 mm (0.20 in)
Recommended primer:
SUMITOMO 3MK-500 or equivalent
Recommended two-sided tape:
SUMITOMO 3M5305 or equivalent
2) Using an infrared lamp, heat body panel to 40 to
60
°
C (104 to 140
°
F) and rear surface of side pro-
tector to 20 to 30
°
C (68 to 86
°
F).
3) Remove tack paper from two-sided paper. While
aligning clips with holes in body panel, attach two-
sided tape to side protector and body panel with a
force of more than 49 N (5 kgf, 11 lb) with roller. Do
not allow air to enter mating surface of the two.
CAUTION:
• To maintain adhesive power, do not wash the
vehicle for 24 hours after tape application.
• Push clip in securely using hands.
(To prevent deformation, do not use excessive
force.)
(1) Front door part
(2) Rear door part
EI-00157
( 1 )
( 2 )
EI-27
EXTERIOR/INTERIOR TRIM
COWL PANEL
8. Cowl Panel
A: REMOVAL
1) Open hood.
2) Remove wiper arm. <Ref. to WW-12, REMOV-
AL, Front Wiper Arm.>
3) Remove front panel seal.
4) Remove clips (A) and cowl side panel (C). Loos-
en clips (D) on six positions, and remove cowl side
panel.
B: INSTALLATION
Install in the reverse order of removal.
EI-00158
EI-00159
:
( B )
( A )
( A )
( C )
( C )
( D )
EI-28
EXTERIOR/INTERIOR TRIM
SPOILER
9. Spoiler
A: REMOVAL
1) Open trunk lid.
2) Disconnect connector (a) of high-mounted stop
light.
3) Remove mounting nut of rear spoiler to remove
rear spoiler.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Clean mounting surfaces of trunk lid and spoiler
before installation.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.46 ft-lb)
EI-00160
( a )
EI-29
EXTERIOR/INTERIOR TRIM
SIDE SILL SPOILER
10.Side Sill Spoiler
A: REMOVAL
Remove clips (1 on front, 6 on lower, 1 on side), re-
move side spoiler.
B: INSTALLATION
Install in the reverse order of removal.
EI-00161
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст