Subaru Legacy III (2000-2003 year). Service manual — part 967
SL-24
SECURITY AND LOCKS
REAR OUTER HANDLE
9. Rear Outer Handle
A: REMOVAL
1) Remove the rear door trim. <Ref. to EI-31, RE-
MOVAL, Rear Door Trim.>
2) Remove the sealing cover. <Ref. to EB-16, RE-
MOVAL, Rear Sealing Cover.>
3) Remove the rear inner remote. <Ref. to SL-23,
REMOVAL, Rear Inner Remote.>
4) Remove the rear door latch assembly. <Ref. to
SL-25, REMOVAL, Rear Door Latch Assembly.>
5) Remove the two bolts and nut. Remove the rear
outer handle.
CAUTION:
Do not use excessive force to remove the door
panel. This will deform it.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure the outer handle works properly after in-
stallation.
C: INSPECTION
1) Make sure the rod is not deformed.
2) Make sure the lever and rod work smoothly.
SL-00078
SL-25
SECURITY AND LOCKS
REAR DOOR LATCH ASSEMBLY
10.Rear Door Latch Assembly
A: REMOVAL
1) Disconnect ground cable from battery.
2) Remove the rear door trim. <Ref. to EI-31, RE-
MOVAL, Rear Door Trim.>
3) Remove the sealing cover. <Ref. to EB-16, RE-
MOVAL, Rear Sealing Cover.>
4) Remove the rear inner remote. <Ref. to SL-23,
REMOVAL, Rear Inner Remote.>
5) Remove the three screws and bolt.
6) Disconnect the connector. Remove the rear door
latch assembly.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure the lock works properly after installation.
C: INSPECTION
1) Make sure the rod is not deformed.
2) Make sure the lever and rod work smoothly.
SL-00079
SL-26
SECURITY AND LOCKS
REAR DOOR LOCK ACTUATOR
11.Rear Door Lock Actuator
A: REMOVAL
1) Remove the rear door latch assembly. <Ref. to
SL-25, REMOVAL, Rear Door Latch Assembly.>
2) Remove the bolt. Remove the rear door lock ac-
tuator.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure the lock works properly after installation.
C: INSPECTION
1) Disconnect the door lock actuator harness con-
nector.
2) Connect the battery to the door lock actuator ter-
minals.
If NG, replace the door lock actuator.
Terminal No.
Actuator operation
No. 2 (+) and No. 4 (–)
Unlocked
→
Locked
No. 4 (+) and No. 2 (–)
Locked
→
Unlocked
SL-00080
SL-00076
2 1
4 3
2 1
4 3
SL-27
SECURITY AND LOCKS
REAR GATE OUTER HANDLE
12.Rear Gate Outer Handle
A: REMOVAL
1) Remove the rear gate lower trim. <Ref. to EI-44,
REMOVAL, Rear Gate Trim.>
2) Remove the rear gate latch rod.
3) Remove the nut holding the rear gate outer han-
dle, and then remove the rear gate outer handle.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure the outer handle works properly after in-
stallation.
C: INSPECTION
1) Inspect the rod for deformation.
2) Make sure the lever and rod move smoothly.
SL-00081
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст