Infiniti Q45 (FY33). Manual — part 268
I
from the lighting switch terminal
q
10
.
With power and ground supplied, the low beam headlamps illuminate.
High beam operation/flash-to-pass operation
When the lighting switch is turned to 2ND and HIGH (“A”) or PASS (“C”) positions, ground is supplied
I
to headlamp relay terminal
q
2
I
from the lighting switch terminal
q
12
.
Headlamp relay is then energized, and power is supplied
I
from the headlamp relay terminal
q
6
I
to terminal
q
2
of the LH headlamp, and
I
to combination meter terminal
q
22
for the HIGH BEAM indicator
I
from headlamp relay terminal
q
3
I
to terminal
q
2
of the RH headlamp.
Ground is supplied
I
to terminal
q
3
of the LH headlamp, and
I
to combination meter terminal
q
23
I
from the lighting switch terminal
q
6
I
to terminal
q
3
of the RH headlamp
I
from the lighting switch terminal
q
9
.
With power and ground supplied, the high beam headlamps illuminate.
AUTO LIGHT OPERATION
BCM is connected to the optical sensor. The optical sensor sends a signal to BCM according to outside
brightness.
When the lighting switch is turned to AUTO position, ground is supplied
I
to BCM terminal
q
14
I
from the lighting switch terminal
q
42
.
When ignition switch is set to ON or START and outside is darker than the prescribed level, ground is sup-
plied
I
to headlamp relay terminal
q
2
I
from the BCM terminal
q
5
.
Headlamp relay is then energized, and headlamps (Low or High) illuminate according to switch position
Auto light operation allows headlamps to turn off when outside is brighter than the prescribed level.
Or the ignition switch is turned to OFF position. (When shut off delay function is canceled.)
For parking, license and tail lamp auto operation, refer to “PARKING, LICENSE AND TAIL LAMPS”.
SHUT OFF DELAY
While the headlamps are lit in the auto-light operation mode, the ignition switch is turned from the “ON” to the
“OFF” position. The BCM no longer receives a voltage signal at terminal
q
68
. This starts the auto light shut off
delay timer. The timer is set based on the resistance value at BCM terminal
q
57
. With the timer running, the
headlamps remain lit. When the timer reaches the end of its cycle, the headlamps turn off. Headlamp light-
ing time can be adjusted from about 0 to 3 minutes. (This function is not applicable to the tail lamps.)
VEHICLE SECURITY SYSTEM
The vehicle security system will flash the high beams if the system is triggered. Refer to “VEHICLE SECU-
RITY (THEFT WARNING) SYSTEM — IVMS”, EL-416.
GI
MA
EM
LC
EC
FE
AT
PD
FA
RA
BR
ST
RS
BT
HA
IDX
HEADLAMP (FOR U.S.A.) — CONVENTIONAL TYPE —
System Description (Cont’d)
EL-63
Schematic
TEL826B
HEADLAMP (FOR U.S.A.) — CONVENTIONAL TYPE —
EL-64
Wiring Diagram — H/LAMP —
TEL720B
GI
MA
EM
LC
EC
FE
AT
PD
FA
RA
BR
ST
RS
BT
HA
IDX
HEADLAMP (FOR U.S.A.) — CONVENTIONAL TYPE —
EL-65
TEL721B
HEADLAMP (FOR U.S.A.) — CONVENTIONAL TYPE —
Wiring Diagram — H/LAMP — (Cont’d)
EL-66
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст