Acura RL (1996-2004 year). Manual — part 573
![](/vehicles/shign/ecital/fofa/milo.png)
Headliner
Removal (cont'd)
5. Remove the clips and roof trim, detach the rear
clips, then remove the headliner.
Clip locations
FASTENER
HEADLINER
JOINT
ROOF
TRIM
6. Remove the headliner through the passenger's door
opening.
7. Installation is the reverse of the removal procedure.
NOTE:
When inserting the headliner through the door
opening, be careful not to fold or bend it. Also,
be careful not to scratch the body.
Check that both sides of the headliner are
securely attached to the trim.
When installing the roof trim, install the joint
toward the rear.
Main Menu
Table of Contents
![](/vehicles/shign/ecital/fofa/aviruryonoma.png)
Carpet
Removal
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
Restraints (
) before performing repairs or service.
1. Remove:
Front and rear side trim (see page
Front and rear door trim (see page
Front seat belt lower anchor (see
Console panel and rear console, '96 - 98 models
(see page
Console panel and rear console, '99 - 01 models
(see page
Dashboard lower cover (passenger's) (see page
2. Remove the accelerator pedal stop and footrest.
Bolt locations, 2
Nut locations, 2
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
FOOTREST
ACCELERATOR
PEDAL STOP
Main Menu
Table of Contents
![](/vehicles/shign/ecital/fofa/she.png)
3. Remove the console lower carpet from each side.
Cut area in the carpet, then pull it back as shown.
Clip locations
RIGHT CONSOLE
LOWER CARPET
SRS
UNIT
LEFT CONSOLE
LOWER CARPET
HOOKS
4. Detach the retainers, then remove the carpet.
NOTE: Take care not to damage, wrinkle, or twist
the carpet.
Clip locations, 4
CARPET
FASTENERS
RETAINERS
SEAT
CUSHION
CLIP
SEAT CUSHION
CLIP
SEAT
HARNESS
5. Installation is the reverse of the removal procedure.
NOTE:
Take care not to damage, wrinkle, or twist the
carpet.
Make sure the seat harness is routed correctly.
If necessary, replace any damaged clips.
Reattach the cut area in the carpet with a wire
tie as follows.
a. Tie a string to the end of the carpet, then slip
the carpet under the heater unit by pulling the
string.
STRING
SLITS
CARPET
b. Reattach with a wire tie.
WIRE TIE
CARPET
SEAT
HARNESS
RETAINERS
Main Menu
Table of Contents
![](/vehicles/shign/ecital/fofa/htare.png)
Console Panel/Rear Console
Removal — '96 - 98 Models
CAUTION: When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
NOTE: Take care not to scratch the console panel, rear console, front seat, and related parts.
Disassemble in numbered sequence.
Bolt, screw locations
6
x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
A/T GEAR POSITION
INDICATOR TRIM
Disconnect the seat
heater switch connectors
and indicator light bulb
socket.
CONSOLE PANEL
Disconnect the
cigarette lighter
connector.
Clip locations
SEAT HEATER
SWITCH
(driver's)
SEAT HEATER
SWITCH
(passenger's)
BEVERAGE
HOLDER
CIGARETTE
LIGHTER
CONNECTOR
REAR
CONSOLE
REAR HEATER
COVER
Installation is the reverse of the removal procedure.
NOTE:
If necessary, replace any damaged clips.
Make sure the wire harnesses are not pinched.
Make sure the connectors and bulb socket are connected properly.
INDICATOR LIGHT
BULB SOCKET
HOOK
HOOKS
CONNECTORS
HOOKS
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст