Acura RL (1996-2004 year). Manual — part 572
![](/vehicles/shign/ecital/fofa/vob.png)
Interior
Component Location Index
SRS components are located in the areas marked with an asterisk (*). Review the SRS component locations, precautions,
and procedures in the Restraints (
) before performing repairs or service.
*
DASHBOARD
Component Removal/Installation,
page
REAR SIDE
REAR CONSOLE
Removal — '96 - 98 Models, page
Removal — '99 - 01 Models, page
*CARPET
SPARE TIRE
LID
ROOF SIDE
TRIM
Main Menu
Table of Contents
![](/vehicles/shign/ecital/fofa/ulakerifo.png)
Interior Trim
Removal
CAUTION:
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
NOTE: Take care not to bend or scratch the trim and panels.
: Clip, hook locations
ROOF SIDE TRIM
FRONT DOOR Remove the grab handle
HOOKS
FRONT PILLAR TRIM
TRIM
Remove the grab handle
(passenger's, see page
).
(see page
).
REAR PILLAR TRIM
Remove the rear seat cushion
and rear seat-back (see page
).
HOOK
RIGHT KICK
PANEL
LEFT KICK
PANEL
FRONT SEAT BELT
LOWER ANCHOR
(see
REAR CENTER SEAT BELT
LOWER ANCHOR
('98-01 models,
see
REAR SHELF
Remove the rear seat
cushion and rear seat-back
(see page
).
'98 - 01 models:
Remove the center seat belt lower
anchor bolt (see
).
'00 - 01 models:
Remove the child seat tether anchors
(see
).
SLIDER
SHOULDER
ANCHOR
ADJUSTER
Installation is the reverse of the removal procedure.
NOTE:
If necessary, replace any damaged clips.
Before installing the center pillar trim, lower the
shoulder anchor adjuster and the slider of the
center pillar trim fully.
Before installing the anchor bolts and rear pillar
trim, make sure there are no twists or kinks in
the seat belts.
'00 - 01 models: Make sure the child seat tether
anchors are installed securely.
REAR SEAT BELT
LOWER ANCHOR
(see
CENTER PILLAR
TRIM
FRONT SIDE
TRIM
REAR SIDE
TRIM
SLIDER
REAR DOOR
TRIM
Main Menu
Table of Contents
![](/vehicles/shign/ecital/fofa/ildia.png)
Trunk Trim
Removal
CAUTION:
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
NOTE: Take care not to bend or scratch the trim and panels.
Clip locations
Screw locations, 2
TRUNK SIDE
BOX
TRUNK
HOOK
RIGHT TRUNK
SIDE TRIM
NOTE: Do not push the
inner clip in too far.
CLIP
REAR TRIM
PANEL
CD CHANGER
COVER
(for some models)
LEFT TRUNK
SIDE TRIM
TRUNK FRONT
TRIM
Installation is the reverse of the removal procedure.
NOTE:
If necessary, replace any damaged clips.
To install the F clips, pull the inner clip up, install
the clip, then push the inner clip until it's flush.
SPARE TIRE
LID
UPPER
TRIM
Main Menu
Table of Contents
![](/vehicles/shign/ecital/fofa/kierenthelu.png)
Headliner
Removal
CAUTION: When prying with a flat-tip screwdriver,
wrap it with protective tape to prevent damage.
NOTE:
Take care not to bend and scratch the headliner.
Be careful not to damage the dashboard and other
interior trim.
1. Remove the grab handles.
Bolt locations, 2
ACCESS
COVER
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
ACCESS
COVER
Remove:
• Rear seat cushion and rear seat-back (see page
Front and rear side trim (see page
Front and rear door trim (see page
Window antenna terminal cover (see page
3. Remove the sunvisor and holder from each side.
Disconnect both positive terminals or 2P connector
(with Homelink, remove the control panel).
Screw locations
POSITIVE
TERMINAL
SUNVISOR
4. Remove the sunglasses holder.
Screw locations, 2
SUNGLASSES
HOLDER
HOOKS
HOLDER
GRAB
HANDLE
HOOKS
ACCESS
COVER
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст