Chery Tiggo 5 (T21). Service manual — part 190
17–
14
17
ON-VEHICLE SERVICE
Transmission Oil
Replacement
1. Turn off all the electrical equipment and ignition switch.
2. Raise the vehicle to a proper height.
3. Place a recovering container under the transmission drain hole.
4. Using a wrench, loosen the transmission retaining plug
(arrow).
5. Using a wrench, loosen the transmission filler plug
(arrow). Replace the drain plug washer and tighten the
drain plug after draining transmission oil.
(Tightening torque: 40 ± 6 N·m)
6. Fill transmission oil.
a. Make sure that transmission drain plug has been tightened in place.
CAUTION
Replace transmission oil only when engine stops and transmission cools down.
Before installation, replace drain/retaining plug washer with a new one.
RT21170040
RT21170050
CAUTION
Only use transmission oil approved by Chery Automobile Co., Ltd.
17–
15
17
b. Using a filling tool, fill transmission oil to the
transmission filler until it overflows.
c. Replace the retaining plug washer and tighten the retaining plug after filling.
(Tightening torque: 40 ± 6 N·m)
Transmission Oil Type
RT21170060
Model
1.5 L MT
Transmission Oil Type
API GL-4, 75W-90
Filling Capacity
2.2 L ± 0.1 L
17–
16
17
Differential Oil Seal
Removal
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Raise the vehicle with a lifter.
2. Drain transmission oil.
a. Remove the retaining plug and washer.
b. Remove the drain plug and washer, and drain the transmission oil.
c. Install the new washer and drain plug.
(Tightening torque: 40 ± 6 N·m)
3. Remove the front left wheel (
4. Remove the left drive shaft (
).
5. Pull out the oil seal with a puller.
Installation
1. Apply an appropriate amount of transmission oil to the lip of new oil seal.
2. Using a special tool and a hammer, tap in the oil seal.
WARNING
Make sure to wear safety equipment to prevent accidents.
Check if safety lock of lifter is locked when performing vehicle lift repair and inspection.
ENVIRONMENTAL PROTECTION
Drained transmission oil should be collected with a recovering tool.
RT21170070
RT21170080
17–
17
17
3. Fill transmission oil.
Other procedures are in the reverse order of removal.
CAUTION
DO NOT damage the oil seal during installation.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст