Chery Tiggo 5 (T21). Service manual — part 191
17–
18
17
Select and Shift Cable
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the battery (
).
4. Remove the air filter assembly (
).
5. Disconnect the select and shift cable from the transmission.
a. Remove the cotter pins (arrow) connecting select and
shift cable with transmission gear shift mechanism.
b. Remove the flexible shaft clamps (arrow) and select
and shift cable.
6. Remove the auxiliary fascia console (
7. Remove the fixing bolts between gear select and shift cable and body.
8. Disconnect the select and shift cable from gear shift control mechanism.
a. Remove the flexible shaft clamps and cotter pins
connecting select and shift cable with gear shift
control mechanism.
9. Remove the gear select and shift cable.
RT21170090
RT21170100
RT21170110
17–
19
17
Installation
Installation is in the reverse order of removal.
CAUTION
DO NOT install the select and shift cable in reverse position during installation.
17–
20
17
Gear Shift Control Mechanism
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the auxiliary fascia console (
4. Remove the gear shift control mechanism.
a. Remove the flexible shaft clamps and cotter pins
connecting select and shift cable with gear shift
control mechanism.
b. Remove the fixing bolts from gear shift control
mechanism, and remove the gear shift control
mechanism.
(Tightening torque: 23 ± 2 N·m)
Installation
Installation is in the reverse order of removal.
RT21170110
RT21170130
17–
21
17
Transmission Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the battery (
).
4. Remove the battery bracket (
5. Remove the air filter assembly (
).
6. Drain transmission oil.
7. Remove the front wheels (
).
8. Remove the drive shaft(
).
9. Use an engine equalizer to hang the engine.
10.Remove the flexible shaft clamps and cotter pins connecting select and shift cable with gear shift
mechanism.
11.Disconnect the back-up light switch connector, ground
wire and clutch line bracket II.
12.Remove the crankshaft position sensor.
a. Remove the fixing bolt from crankshaft position sensor, and remove the crankshaft position sensor.
13.Remove the left mounting (
).
14.Remove the front mounting (
15.Remove the rear mounting (
).
16.Remove the clutch release cylinder from transmission (
17.Remove the starter (
).
18.Remove the transmission.
a. Support the transmission assembly with a
transmission carrier.
b. Remove the transmission lower coupling bolts, and
remove the seal plate.
(Tightening torque: 50 ± 5 N·m)
RT21170140
RT21170150
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст