Jaguar XJ (X350). Service manual — part 552
Exhaust Manifold RH (30.15.56)
Removal
1 . Remove the right-hand exhaust gas recirculation (EGR) valve.
For additional information, refer to Exhaust Gas Recirculation (EGR) Valve RH
2 . Remove the right-hand turbocharger.
For additional information, refer to Turbocharger RH
3 . Remove the exhaust manifold front heat shield.
4 . Remove the exhaust manifold rear heat shield.
5 . NOTE:
New exhaust manifold retaining studs must be fitted if the old studs are removed.
Remove the exhaust manifold.
Remove and discard the retaining nuts.
6 . Remove and discard the exhaust manifold gasket.
Installation
1
.
CAUTION: Ensure the exhaust manifold and gasket are correctly aligned to the
cylinder head and studs.
NOTE:
New exhaust manifold retaining studs must be fitted if the old studs are removed.
To install, reverse the removal procedure.
Install a new exhaust manifold gasket.
Install new exhaust manifold retaining nuts.
Tighten to 23 Nm.
www.
2 . Tighten to 10 Nm.
3 . Tighten to 10 Nm.
Flexplate (12.53.13)
Removal
1 . Remove the transmission.
For additional information, refer to
2 . NOTE:
Prevent the flexplate from rotating.
Remove the flexplate.
Installation
1 . NOTE:
Make sure the crankshaft and flexplate mating faces are clean before installation.
NOTE:
The flexplate will only locate in one position.
NOTE:
Install, but do not tighten, the flexplate retaining bolts.
Install the flexplate.
Prevent the flexplate from rotating.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст