Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 425
6MT-37
Preparation for Overhaul
MANUAL TRANSMISSION AND DIFFERENTIAL
7. Preparation for Overhaul
A: PROCEDURE
1) Clean oil, grease, dirt and dust from the trans-
mission.
2) Attach the transmission to the ST.
ST 18632AA000 STAND ASSY
3) Apply oil to rotating parts before assembly.
4) When reusing disassembled parts, reinstall in
the original positions and directions.
5) Gaskets, lock washers and lock nuts must be re-
placed with new parts.
6) Apply liquid gasket to the specified areas to pre-
vent leakage.
MT-00468
ST
ST
ST
6MT-38
Air Breather Hose
MANUAL TRANSMISSION AND DIFFERENTIAL
8. Air Breather Hose
A: REMOVAL
Disconnect the air breather hose.
B: INSTALLATION
Connect the air breather hose.
C: INSPECTION
Make sure the hose is not cracked or clogged.
MT-01707
MT-01707
6MT-39
Back-up Light Switch
MANUAL TRANSMISSION AND DIFFERENTIAL
9. Back-up Light Switch
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 6MT-31, REMOVAL,
Manual Transmission Assembly.>
2) Disconnect the back-up light switch connector.
3) Disconnect the back-up light switch.
B: INSTALLATION
1) Install the back-up light switch.
NOTE:
Use a new gasket.
Tightening torque:
32 N·m (3.3 kgf-m, 23.6 ft-lb)
2) Connect the back-up light switch connector.
3) Install the manual transmission assembly to the
vehicle. <Ref. to 6MT-33, INSTALLATION, Manual
(A) Back-up light switch connector (gray)
(B) Neutral position switch connector (brown)
(C) Clip
(A) Back-up light switch
(B) Neutral position switch
MT-00471
(A)
(B)
(C)
(C)
MT-00472
(A)
(B)
(A) Back-up light switch
(B) Neutral position switch
(A) Back-up light switch connector (gray)
(B) Neutral position switch connector (brown)
(C) Clip
MT-00472
(A)
(B)
MT-00471
(A)
(B)
(C)
(C)
6MT-40
Back-up Light Switch
MANUAL TRANSMISSION AND DIFFERENTIAL
C: INSPECTION
1) Disconnect the ground cable from battery.
2) Remove the intercooler. <Ref. to IN(STI)-12,
3) Disconnect the transmission harness and chas-
sis harness.
4) Measure the resistance between the back-up
light switch terminals. If it is not within the specifica-
tion, replace the back-up light switch.
(A) Transmission harness connectors
(B) Pitching stopper
Gear shift position
Terminal No.
Standard
Back position
3 and 6
Less than 1 Ω
Other positions
1 MΩ or more
MT-01741
(A)
(B)
2
5
6
1
4
3
MT-00946
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст