Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 13
PI-6
Pre-delivery Inspection
PRE-DELIVERY INSPECTION
(2) Operate the lever using a tool such as a
screwdriver to check that the rear gate is un-
locked normally.
8. FUEL LID OPENER LOCK RELEASE LE-
VER
Operate the fuel lid opener to check that the fuel lid
is unlocked normally. Check that the filler cap is se-
curely closed.
9. ACCESSORY
Check that the following accessories are provided.
• Owner’s manual
• Warranty booklet
• Maintenance note
• Spare key
• Tool set
• Towing hook (eyebolt)
• Spare tire
• Key No. plate
• Security ID plate
• Jack
• Jack handle
4 door model
5 door model
PI-00406
(A) Jack handle
(B) Tool set
(C) Spare tire
(D) Jack
(E) Towing hook (eyebolt)
(A) Jack
(B) Jack handle
(C) Towing hook (eyebolt)
(D) Spare tire
PI-00436
(A)
(B)
(C)
(D)
(E)
PI-00664
(A)
(B)
(C)
(D)
PI-7
Pre-delivery Inspection
PRE-DELIVERY INSPECTION
10.FRONT HOOD LOCK RELEASE SYSTEM
Operate the front hood release knob to check that
the front hood will unlock properly.
Operate the lever (A) and check that the front hood
is opened normally.
11.BATTERY
Check the battery terminals to make sure that there
are no rust or corrosions due to fluid leaks. Check
that the battery caps are securely tightened.
12.BRAKE FLUID
Check the brake fluid amount. If the amount is in-
sufficient, carry out a brake line test to identify
brake fluid leaks and check the brake operation. Af-
ter that, refill the brake fluid tank with the specified
type of fluid.
CAUTION:
If the brake fluid is spilt over exhaust pipe, wipe
it off with cloth to avoid emitting smoke or
causing a fire.
PI-00433
PI-00413
(A)
(A) Cap
(B) Upper level
(C) Lower level
PI-00012
(A)
(B)
(C)
PI-8
Pre-delivery Inspection
PRE-DELIVERY INSPECTION
13.ENGINE OIL
Check the engine oil amount. If the amount of oil is
insufficient, check that no leaks are found. Then, add
the necessary amount of the specified engine oil.
CAUTION:
If any engine oil is spilled on the exhaust pipe,
under cover, wipe off completely to prevent
fires or emission of smoke.
14.TRANSMISSION GEAR OIL
5MT model
Check for leakage of the transmission gear oil. Re-
fer to “5MT” section for transmission gear oil in-
spection. <Ref. to 5MT-22, INSPECTION,
Transmission Gear Oil.>
CAUTION:
If gear oil is spilt over the exhaust pipe, wipe it
off with a cloth to avoid emitting smoke or
causing a fire.
6MT model
Check for leakage of the transmission gear oil.
15.REAR DIFFERENTIAL GEAR OIL
Check for leakage of gear oil from the rear differen-
tial.
16.ENGINE COOLANT
Check the coolant amount on the reservoir. If the
amount of engine coolant is insufficient, check that
no leaks are found. Then, add the necessary
amount of coolant with the specified concentration.
CAUTION:
If any engine coolant is spilled on the exhaust
pipe, wipe off completely to prevent fires or
emission of smoke.
17.CLUTCH FLUID
Check the clutch fluid amount. If the amount of fluid
is insufficient, check that no leaks are found. Then,
add the necessary amount of specified fluid.
CAUTION:
If any clutch fluid is spilled on the exhaust pipe,
wipe off completely to prevent fires or emission
of smoke.
18.WINDOW WASHER FLUID
Check the window washer fluid amount. If the
amount is insufficient, check that no leaks are
found. Then, add the necessary amount of washer
fluid.
(A) Oil level gauge
(B) Engine oil filler cap
(C) “F” line
(D) “L” line
(E) Approx. 1.0 L (1.1 US qt, 0.9 Imp qt)
(F) Notch mark
(A) Oil level gauge
(B) Upper level
(C) Lower level
(C)
(B)
(D)
(E)
(F)
(A)
PI-00460
(B)
(C)
(A)
PI-00564
L
F
(A) Reservoir tank
(B) MIN. level
(C) MAX. level
(A)
(B)
(C)
PM-00076
PI-00409
PI-9
Pre-delivery Inspection
PRE-DELIVERY INSPECTION
19.FRONT HOOD LATCH
Close the front hood. Check that the front hood is
completely latched.
20.KEYLESS ENTRY SYSTEM
Check the keyless entry system operations as fol-
lows:
• Fully open all the door windows.
• Remove the key from the ignition switch and
close all the doors including rear gate.
• Press the “LOCK/ARM” button momentarily on
the keyless transmitter. Check that all the doors be-
come locked, the buzzer sounds once, and the
hazard lights flash once.
• Press the “UNLOCK/DISARM” button momen-
tarily on the keyless transmitter. Check that the
driver’s door is unlocked, the buzzer sounds twice,
and the hazard lights flash twice.
• Within 5 seconds, press the “UNLOCK/DISARM”
button momentarily on the keyless transmitter.
Check that all doors (including rear gate) are un-
locked.
• Lock all the doors including rear gate. Press the
rear gate unlock button to unlock the rear gate.
Check that the buzzer sounds twice, and the haz-
ard lights flash twice. Press the release button and
check that the rear gate opens. (Wagon model)
• Check that the buzzer sounds twice, and the
hazard lights flash twice, when the trunk lid unlock
button is held down to unlock the trunk lid. (Sedan
model)
• Press the “PANIC” button of the keyless trans-
mitter. Check that the panic mode (the horn keeps
sounding) is initiated. Also, check that this condi-
tion continues for 30 seconds or until when any of
the buttons on the keyless transmitter are pressed.
• Press the “LOCK/ARM” button momentarily on
the keyless transmitter with one of the doors (in-
cluding the rear gate) opened. Check that the buzz-
er sounds 5 times, and the hazard light flashes 5
times to notify the door not being fully closed. Next,
close all the doors including rear gate. Check if all
doors are locked and buzzer sounds once and the
hazard light flashes once.
• With one of the doors open (including the rear
gate), press the “LOCK” side of the power door lock
switch. Next, close all the doors including rear gate.
Check if all doors are locked and buzzer sounds
once and the hazard light flashes once.
• Driver’s side
PI-00357
PI-00358
PI-00503
PI-00502
PANIC
PI-00720
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст