Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 475
RS-7
General Description
REAR SUSPENSION
2. GENERAL TOOL
20099PA010
INSTALLER &
REMOVER
• Used for replacing the bushing of the rear
housing.
• Used together with BUSHING REMOVER
(20099FG000).
20099FG000
BUSHING
REMOVER
• Used for replacing the bushing of the rear
housing.
• Used together with INSTALLER & REMOVER
(20099PA010).
TOOL NAME
REMARKS
Alignment tester
Used for measuring wheel alignment.
Toe-in gauge
Used for toe-in measurement.
Jack
Used for removing and installing suspension.
Bearing puller
Used for removing bushings.
Coil spring compressor
Used for disassembling and assembling shock absorber.
ILLUSTRATION
TOOL NUMBER
DESCRIPTION
REMARKS
ST20099PA010
ST20099FG000
RS-8
Wheel Alignment
REAR SUSPENSION
2. Wheel Alignment
A: INSPECTION
NOTE:
Measure and adjust the front and rear wheel align-
ment at a time. Refer to “FS” section for measure-
RS-9
Rear Stabilizer
REAR SUSPENSION
3. Rear Stabilizer
A: REMOVAL
1) Lift up the vehicle, and then remove the rear
wheels.
2) Remove the stabilizer link.
3) Remove the stabilizer clamp.
B: INSTALLATION
CAUTION:
• Be sure to use a new flange nut and self-lock-
ing nut.
• Always tighten the bushing in the state where
the vehicle is at curb weight and the wheels are
in full contact with the ground.
• Align the paint mark end of stabilizer to the
end of bushing when installing.
Install each part in the reverse order of removal.
Tightening torque:
Stabilizer link
38 N·m (3.9 kgf-m, 28 ft-lb)
Stabilizer clamp
30 N·m (3.1 kgf-m, 22.1 ft-lb)
C: INSPECTION
1) Check the bushing for abnormal cracks, fatigue
or damage.
2) Check the stabilizer link for damage.
RS-00251
RS-00252
(1) Identification paint
(2) Bushing
RS-00273
(1)
(2)
RS-10
Rear Trailing Link
REAR SUSPENSION
4. Rear Trailing Link
A: REMOVAL
1) Lift up the vehicle, and then remove the rear
wheels.
2) Remove the bracket, and remove the parking
brake cable from the guide.
3) Remove the trailing link.
B: INSTALLATION
CAUTION:
• Be sure to use a new self-locking nut.
• Always tighten the bushing in the state where
the vehicle is at curb weight and the wheels are
in full contact with the ground.
Install each part in the reverse order of removal.
Tightening torque:
90 N·m (9.2 kgf-m, 66.4 ft-lb)
C: DISASSEMBLY
1. REAR TRAILING LINK BUSHING
Using the ST A and ST B, press the bushing out.
ST A 8998741000 INSTALLER
ST B 499755602
PRESS
(1) Guide
RS-00253
(1)
RS-00254
ST-A
ST-B
RS-00255
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст