Subaru Legacy IV (2008 year). Service manual — part 744
5AT-100
AT Main Case
AUTOMATIC TRANSMISSION
24) Remove the snap ring of the reverse brake
spring retainer.
ST1
18762AA000
COMPRESSOR SPECIAL
TOOL
ST2
18765AA000
COMPRESSOR SUPPORT
ST3
18763AA000
COMPRESSOR SHAFT
25) Remove the spring retainer.
26) Remove the return spring.
27) Apply compressed air.
28) Remove the reverse brake piston.
29) Remove the thrust bearing and the seal ring.
AT-02000
ST3
ST2
ST1
AT-02001
AT-02002
(A) Thrust bearing
(B) Seal ring
AT-02004
AT-02005
(A)
(B)
(A)
(A)
(B)
(A)
AT-04307
5AT-101
AT Main Case
AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Apply ATF to a new seal ring.
2) Install the thrust bearing and a new seal ring to
the drum support.
3) Install the reverse brake piston.
NOTE:
Apply ATF onto the piston sliding surface.
ST1
18762AA000
COMPRESSOR SPECIAL
TOOL
ST2
18765AA000
COMPRESSOR SUPPORT
ST3
18763AA000
COMPRESSOR SHAFT
4) Install the return spring.
5) Install the spring retainer and snap ring.
ST1
18762AA000
COMPRESSOR SPECIAL
TOOL
ST2
18765AA000
COMPRESSOR SUPPORT
ST3
18763AA000
COMPRESSOR SHAFT
6) Install the dish plate.
NOTE:
When installing, make sure that the identification
mark is facing the front side of transmission.
7) Install the drive plate and driven plate.
(A) Thrust bearing
(B) Seal ring
(A)
(B)
(A)
(A)
(B)
(A)
AT-04307
AT-02002
AT-02000
ST3
ST2
ST1
5AT-102
AT Main Case
AUTOMATIC TRANSMISSION
8) Install the leaf spring.
9) Install the retaining plate.
10) Install the snap ring of the reverse brake.
11) Perform the clearance check of reverse brake.
(1) Measure the clearance between retainer
plate and snap ring using thickness gauge.
Standard:
0.7 — 1.1 mm (0.028 — 0.043 in)
(2) If it is out of specification, select a suitable
retainer plate from the following table and as-
semble it.
12) Install the direct clutch assembly.
13) Install the high & low reverse clutch assembly.
(A) Leaf spring
B '
B
B '
B
(A)
(A)
AT-03364
AT-01998
Retainer plate
Part No.
Thickness mm (in)
31567AB100
4.2 (0.165)
31567AB170
4.4 (0.173)
31567AB180
4.6 (0.181)
31567AB190
4.8 (0.189)
31567AB200
5.0 (0.197)
AT-02372
AT-01997
AT-01996
5AT-103
AT Main Case
AUTOMATIC TRANSMISSION
14) Install the thrust needle bearing of the high &
low reverse clutch.
15) Install the middle & rear sun gear assembly.
16) Install the rear carrier assembly.
17) Install the middle carrier assembly.
AT-01995
AT-01994
AT-01993
AT-01992
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст