Subaru Legacy IV (2008 year). Service manual — part 1068
COM-4
Horn
COMMUNICATION SYSTEM
3. Horn
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the three clips and peel the right side
lower mud guard upward.
3) Remove the horn bracket mounting bolt (A).
4) Disconnect the harness connector and remove
the horn assembly (B).
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
C: INSPECTION
With 12 V direct current supplied between horn ter-
minals, check that the horn sounds properly.
COM00043
(B)
(A)
COM00053
COM00008
COM-5
Horn Switch
COMMUNICATION SYSTEM
4. Horn Switch
A: REMOVAL
CAUTION:
Before servicing, be sure to read the notes in
the “AB” section for proper handling of the
driver’s airbag module. <Ref. to AB-4, CAU-
TION, General Description.>
NOTE:
Horn switch is a unit with the driver’s airbag mod-
ule.
1) Disconnect the ground cable from the battery.
2) Remove the driver’s airbag module. <Ref. to AB-
14, REMOVAL, Driver’s Airbag Module.>
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Measure the resistance between horn switch termi-
nal and airbag module bracket.
(1) Horn switch terminal
(2) Airbag module bracket
Switch position
Terminal No.
Resistance
When horn switch
is pushed.
Horn switch ter-
minal and airbag
module bracket
Less than 1
:
When horn switch
is not pushed.
1 M
: or more
(2)
(1)
COM00037
COM-6
Horn Switch
COMMUNICATION SYSTEM
GW-2
General Description
GLASS/WINDOWS/MIRRORS
1. General Description
A: COMPONENT
1. FIXED GLASS (SEDAN MODEL)
(1)
Windshield glass
(5)
Locating pin
(9)
Clip
(2)
Dam rubber
(6)
Rear window glass
(10)
Seal
(3)
Molding
(7)
Six light glass
(11)
Spacer
(4)
Rearview mirror mount
(8)
Bracket
GW-00538
(2)
(6)
(2)
(7)
(8)
(9)
(2)
(3)
(5)
(10)
(3)
(8)
(1)
(2)
(3)
(4)
(5)
(11)
(9)
(9)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст