Subaru Legacy III (2000-2003 year). Service manual — part 985
EI-42
EXTERIOR/INTERIOR TRIM
ROOF TRIM
21.Roof Trim
A: REMOVAL
CAUTION:
When removing clip, use great care not to dam-
age the roof trim.
1. SEDAN
1) Disconnect ground cable from battery.
2) Remove sunroof switch. (Sunroof equipped
model) <Ref. to SR-14, REMOVAL, Sunroof
Switch.>
3) Remove room light. <Ref. to LI-32, REMOVAL,
Room Light.>
4) Remove sun visor and hook of both sides. <Ref.
to EI-41, REMOVAL, Sun Visor.>
5) Remove assist grips (A).
6) Remove sunroof garnish (A).
7) Remove upper inner trim. <Ref. to EI-38, RE-
MOVAL, Upper Inner Trim.>
8) Remove rear window mole (A) of both sides.
9) Remove screw (B) of rear quarter lower trim
shown in the figure.
10) Remove rear quarter upper trim (C) of both
sides.
11) Remove clips, and then remove roof trim.
2. WAGON
1) Open the rear sunroof, and then remove four
clips. (Sunroof equipped model)
2) Disconnect ground cable from battery.
3) Remove sunroof switch. (Sunroof equipped
model) <Ref. to SR-14, REMOVAL, Sunroof
Switch.>
4) Remove room light and luggage room light.
<Ref. to LI-32, REMOVAL, Room Light.> and
<Ref. to LI-33, REMOVAL, Luggage Room Light.>
5) Remove sun visor and hook of both sides. <Ref.
to EI-41, REMOVAL, Sun Visor.>
EI-00201
( A )
EI-00202
( a )
EI-00197
( A )
( B )
( C )
EI-00204
( A )
( A )
EI-00205
EI-43
EXTERIOR/INTERIOR TRIM
ROOF TRIM
6) Remove assist grips (A).
7) Remove upper inner trim. <Ref. to EI-38, RE-
MOVAL, Upper Inner Trim.>
8) Remove rear window mole of both sides (A).
9) Remove screws (B) and clips (C) of rear quarter
lower trim shown in the figure.
10) Remove rear quarter upper trim (D) of both
sides.
11) Remove rear rail trim (E).
12) Remove cover (B) while detaching snap lock
carefully. Put the rear center seat belt tongue (A)
out to the other side of the trim through the hole.
13) Remove clips and then remove roof trim.
B: INSTALLATION
Install in the reverse order of removal.
(1) Hook pawl
EI-00201
( A )
EI-00207
: ( 1 )
(1) Snap lock
EI-00208
( A )
( B )
EI-00209
: ( 1 )
EI-44
EXTERIOR/INTERIOR TRIM
REAR GATE TRIM
22.Rear Gate Trim
A: REMOVAL
CAUTION:
Be careful not to damage clips or their holes.
1) Remove clips and detach rear gate lower trim
(A).
2) Remove caps and screws, and then detach
high-mounted stop light cover (A).
3) Remove rear gate upper trim (A).
B: INSTALLATION
Install in the reverse order of removal.
(1) Hook pawl
EI-00210
( A )
EI-00211
( A )
EI-00212
:
( A )
( 1 )
EI-45
EXTERIOR/INTERIOR TRIM
REAR SHELF TRIM
23.Rear Shelf Trim
A: REMOVAL
1) Remove high-mounted stop light.
2) Remove rear seat backrest. <Ref. to SE-17, SE-
DAN, REMOVAL, Rear Seat.>
3) Remove inner seat belt RH, then disconnect in-
ner seat belt RH (A) and outer seat belt center (B).
4) Detach rear shelf trim through each rear outer
seat belt from slits (A) and hole (B) of rear shelf
trim.
B: INSTALLATION
Install in the reverse order of removal.
(1) Clip
EI-00213
EI-00214
( A )
( B )
EI-00215
( 1 )
:
( A )
( A )
( B )
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст