Subaru BRZ (2012 year). Service manual — part 15
PI-7
Pre-delivery Inspection
PRE-DELIVERY INSPECTION
9. ACCESSORY
Check that the following accessories are provided.
• Owner’s manual
• Warranty booklet
• Maintenance note
• Spare key
• Key No. plate
• Jack
• Tool set
• Spare tire
10.FRONT HOOD LOCK RELEASE
Operate the front hood release lever to check that
the front hood is unlocked normally.
Operate the lever (A) and check that the front hood
is opened normally.
11.BATTERY
Check the battery terminals to make sure that there
are no rust or corrosions due to fluid leaks. Check
that the battery caps are securely tightened.
(A) Towing hook (eyebolt)
(B) Jack
(A) Jack handle
(A) Spare tire
(A)
(B)
PI-00755
(A)
PI-00756
(A)
PI-00757
(A) Cap
(B) Upper level
(C) Lower level
PI-00780
PI-00760
(A)
PI-00012
(A)
(B)
(C)
PI-8
Pre-delivery Inspection
PRE-DELIVERY INSPECTION
12.BRAKE FLUID
Check the brake fluid amount. If the amount is in-
sufficient, carry out a brake line test to identify
brake fluid leaks and check the brake operation. Af-
ter that, refill the brake fluid tank with the specified
type of fluid.
CAUTION:
If the brake fluid is spilt over exhaust pipe, wipe
it off with cloth to avoid emitting smoke or
causing a fire.
13.ENGINE OIL
1) Park the vehicle on a level surface.
2) Remove the oil level gauge and wipe away the
oil.
3) Reinsert the oil level gauge all the way. Be sure
that the oil level gauge is correctly inserted and
properly orientated.
4) Pull out the oil level gauge again, and check the
oil level. If the engine oil level is below “L” mark,
add oil to bring the level up to “F” mark.
5) Start the engine, and spread the oil in engine.
6) After turning off the engine, wait five minutes or
more for the oil to return to the oil pan before check-
ing the oil level.
NOTE:
To prevent overfilling of engine oil, do not add oil
above “F” mark when the engine is cold.
14.TRANSMISSION GEAR OIL
Check for leakage of the transmission gear oil.
CAUTION:
If gear oil is spilt over the exhaust pipe, wipe it
off with a cloth to avoid emitting smoke or
causing a fire.
15.REAR DIFFERENTIAL GEAR OIL
Check for leakage of gear oil from the rear differen-
tial.
CAUTION:
If the rear differential gear oil is spilt over ex-
haust pipe, wipe it off with cloth to avoid emit-
ting smoke or causing a fire.
(A) MAX. level
(B) MIN. level
PI-00791
(A)
(B)
(A) Oil level gauge
(B) Oil filter
(C) Oil filler cap
(D) “F” mark
(E) “L” mark
(F) Approx. 1 L (1.1 US qt, 0.9 Imp qt)
PI-00812
(D)
(E)
(A)
(C)
(B)
(F)
PI-9
Pre-delivery Inspection
PRE-DELIVERY INSPECTION
16.ENGINE COOLANT
Check the coolant amount on the reservoir. If the
amount of engine coolant is insufficient, check that
no leaks are found. Then, add the necessary
amount of coolant with the specified concentration.
CAUTION:
If the coolant is spilt over exhaust pipe, wipe it
off with cloth to avoid emitting smoke or caus-
ing a fire.
17.CLUTCH FLUID
Check the clutch fluid amount. If the amount of fluid
is insufficient, check that no leaks are found. Then,
add the necessary amount of specified fluid.
CAUTION:
If any clutch fluid is spilt on the exhaust pipe,
wipe it off with a cloth to avoid emitting smoke
or causing a fire.
18.WINDOW WASHER FLUID
Check the window washer fluid amount. If the
amount of washer fluid is insufficient, check that no
leaks are found. Then, add the necessary amount
of washer fluid.
19.FRONT HOOD LATCH
Close the front hood. Check that the front hood is
completely latched.
20.KEYLESS ENTRY SYSTEM
Check the keyless entry system operations as fol-
lows:
• Fully open all the door windows.
• Remove the key from ignition switch, and then
close all doors. (model without keyless access
function)
• Turn the ignition switch to OFF and close all
doors (model with keyless access function).
• Press the “LOCK” button momentarily on the
keyless transmitter. Check that all the doors be-
come locked, the buzzer sounds once, and the
hazard lights flash once.
• Press the “UNLOCK” button momentarily on the
keyless transmitter. Check that the driver’s door is
unlocked, the buzzer sounds twice, and the hazard
lights flash twice.
• Within five seconds, briefly press the “UNLOCK”
button on the keyless transmitter. Check that the all
doors are unlocked, the buzzer sounds twice, and
the hazard lights flash twice.
• Check that the buzzer sounds once, when the
trunk lid unlock button is held down to unlock the
trunk lid.
(A) MAX. level
(B) MIN. level
PI-00792
(A)
(B)
PI-00815
PI-00781
PI-00782
PI-00783
PI-10
Pre-delivery Inspection
PRE-DELIVERY INSPECTION
• Press the “PANIC” button of the keyless trans-
mitter. Check that the panic mode (the horn keeps
sounding) is initiated. Also, check that this condi-
tion continues for 30 seconds or until when any of
the buttons on the keyless transmitter are pressed.
• Momentarily press the “LOCK” button on the
keyless transmitter with one door open. Check that
the buzzer sounds to warn that the door is not fully
closed.
• Driver’s side
• Passenger’s side
Alarm sound operational check
• Models with the keyless access function use the
buzzer and sounds the alarm when the door is
locked or unlocked. The alarm sound can be turned
OFF. To turn the alarm sound from ON to OFF,
close all doors, (with the key not inserted in the key
cylinder), hold down the “UNLOCK” side of the
power door lock switch and insert the key in the key
cylinder. Within 10 seconds, insert and take out the
key for 5 times or more, and within 10 seconds after
that, open and close the driver’s door. With the
door closed, the hazard light will flash 3 times, indi-
cating that the alarm sound has been turned OFF.
To turn the alarm sound from OFF to ON, perform
this procedure again. The hazard light will flash 3
times, indicating that the alarm has been turned
ON.
21.KEYLESS ACCESS FUNCTION
CAUTION:
• When performing the check, check one ac-
cess key at a time, separating individual keys.
• Do not leave any separated access keys in
the vehicle.
NOTE:
The following inspections show the initial settings.
When the settings are different from the initial set-
tings, use Subaru Select Monitor to check the de-
tails of each setting for inspections.
• While carrying the access key, check that the
room light illuminates when you move close to the
front door handles of the vehicle whose doors are
all locked.
• While carrying the access key, check that the
driver’s door unlocks and the hazard lights flash by
grasping the driver’s side front door knob (touching
the touch sensor).
• While carrying the access key, check that all
doors are unlocked and the hazard lights flash by
grasping the front passenger’s door knob (touching
the touch sensor).
• While carrying the access key, check that all
doors are locked and the hazard lights flash when
touching the front door lock-touch sensor.
PI-00784
PI-00776
PI-00779
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст