Infiniti QX56 (JA60). Manual — part 545
PRECAUTIONS
FL-3
< PRECAUTION >
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
5. When the repair work is completed, return the ignition switch to the
″LOCK″ position before connecting
the battery cables. (At this time, the steering lock mechanism will engage.)
6. Perform a self-diagnosis check of all control units using CONSULT-III.
![](/vehicles/zatt/vend/genn/hon.png)
FL-4
< PRECAUTION >
FUEL SYSTEM
FUEL SYSTEM
General Precaution
INFOID:0000000005149530
WARNING:
When replacing fuel line parts, be sure to observe the following.
• Put a “CAUTION: FLAMMABLE” sign in the workshop.
• Be sure to work in a well ventilated area and furnish workshop with a CO
2
fire extinguisher.
• Do not smoke while servicing fuel system. Keep open flames and sparks away from the work area.
CAUTION:
• Before removing fuel line parts, carry out the following procedures:
- Put drained fuel in an explosion-proof container and put the lid on securely. Keep the container in
safe area.
- Release fuel pressure from the fuel lines. Refer to
- Disconnect the battery negative terminal.
• Always replace O-rings and clamps with new ones.
• Do not kink or twist hoses when they are being installed.
• After connecting the fuel tube quick connectors, make sure
the quick connectors are secure.
Ensure that the connector and resin tube do not contact any
adjacent parts.
• After installing tubes, make sure there is no fuel leakage at
connections in the following steps.
- Apply fuel pressure to fuel lines with turning ignition switch
ON (with engine stopped). Then check for fuel leaks at con-
nections.
- Start the engine and rev it up and check for fuel leaks at con-
nections.
• Use only a Genuine NISSAN fuel filler cap as a replacement. If
an incorrect fuel filler cap is used, the MIL may come on.
• For servicing “Evaporative Emission System” parts, refer to
EC-493, "Removal and Installation"
.
• For servicing “On Board Refueling Vapor Recovery (ORVR)”
parts, refer to
EC-491, "How to Detect Fuel Vapor Leakage"
.
PBIC1268E
![](/vehicles/zatt/vend/genn/ind.png)
PREPARATION
FL-5
< PREPARATION >
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000005149531
The actual shapes of the Kent-Moore tools may differ from those of the special tools illustrated here.
Commercial Service Tool
INFOID:0000000005149532
Tool number
(Kent-Moore No.)
Tool name
Description
—
(J-46536)
Fuel tank lock ring tool
Removing and installing fuel tank lock ring
LBIA0398E
Tool name
Description
Power tool
Loosening bolts and nuts
PBIC0190E
![](/vehicles/zatt/vend/genn/woownol.png)
FL-6
< BASIC INSPECTION >
FUEL SYSTEM
BASIC INSPECTION
FUEL SYSTEM
Checking Fuel Line
INFOID:0000000005149533
Inspect fuel lines, fuel filler cap and fuel tank for improper attach-
ment, leaks, cracks, damage, loose connections, chafing or deterio-
ration.
If necessary, repair or replace damaged parts.
SMA803A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст