Infiniti QX56 (JA60). Manual — part 978
TM-214
< DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
41. Remove rear extension assembly (2WD models) or adapter case assembly (4WD models) according to
the following procedures.
a. 2WD models
i.
Remove bolts (1 brackets) for rear extension assembly and
transmission case.
• Self-sealing bolts (2)
ii.
Tap rear extension assembly with soft hammer.
iii. Remove rear extension assembly (with needle bearing) from
transmission case.
WCIA0562E
SCIA5028E
SCIA5029E
DISASSEMBLY
TM-215
< DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
b. 4WD models
i.
Remove adapter case to transmission case bolts and terminal
bracket (1).
• Self-sealing bolt (2)
ii.
Tap adapter case assembly using suitable tool.
iii. Remove adapter case assembly (with needle bearing) from
transmission case.
iv. Remove gasket from transmission case.
WCIA0563E
SCIA5201E
SCIA5186E
SCIA5231E
TM-216
< DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
42. Remove bearing race from output shaft.
43. Remove output shaft from transmission case by rotating left and
right.
44. Remove parking gear from output shaft.
45. Remove seal rings from output shaft.
46. Remove needle bearing from transmission case.
SCIA5245E
SCIA5030E
SCIA5247E
SCIA5209E
SCIA5031E
DISASSEMBLY
TM-217
< DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
47. Remove output speed sensor (1) from transmission case.
CAUTION:
• Do not subject it to impact by dropping or hitting it.
• Do not disassemble.
• Do not allow metal filings or any foreign material to get on
the sensor's front edge magnetic area.
• Do not place in an area affected by magnetism.
48. Remove reverse brake snap ring using two flat-bladed screw-
drivers.
NOTE:
Press out snap ring from the transmission case oil pan side gap
using a flat-bladed screwdriver, and remove it using a another
screwdriver.
49. Remove reverse brake retaining plate from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
50. Remove N-spring from transmission case.
51. Remove reverse brake drive plates, driven plates and dish plate
from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
52. Remove snap ring using suitable tool.
: Bolt
JSDIA1321ZZ
SCIA5032E
SCIA5214E
SCIA2322E
SCIA2323E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст