Infiniti QX56 (JA60). Manual — part 806
SB-4
< ON-VEHICLE REPAIR >
SEAT BELTS
ON-VEHICLE REPAIR
SEAT BELTS
Removal and Installation of Front Seat Belt
INFOID:0000000005266528
FRONT SEAT BELT RETRACTOR
Removal
CAUTION:
1.
Assist handle
2.
Assist handle screw cover
3.
D-ring anchor bolt cover
4.
Seat belt buckle
5.
Seat belt retractor and belt assembly
LH
6.
Anchor cover
7.
Seat belt pre-tensioner connector
8.
Center pillar lower finisher
9.
Seat belt anchor bracket
10. Center pillar
11. Center pillar upper finisher
12. Seat belt height adjuster
13. Seat belt height adjuster finisher
AWHIA0231GB
SEAT BELTS
SB-5
< ON-VEHICLE REPAIR >
C
D
E
F
G
I
J
K
L
M
A
B
SB
N
O
P
• Before servicing SRS, turn the ignition switch off, disconnect both battery terminals and wait at least
three minutes.
1. Disconnect both battery terminals, then wait at least three minutes.
2. Remove the center pillar lower finisher. Refer to
INT-14, "Removal and Installation"
3. Remove the retractor anchor bolt, retractor bolt upper, then remove the retractor and belt assembly.
• On RH side, disconnect the seat belt tension sensor.
4. Disconnect the seat belt pre-tensioner electrical connector.
CAUTION:
• For removing pre-tensioner connector, insert a thin
screwdriver (1) wrapped in tape (3) into the notch. Lift the
locking tab to unlock (2), then remove the connector.
• Install the pre-tensioner connector with the locking tab
raised, then push the locking tab into the connector to
lock (4).
Installation
Installation is in the reverse order of removal.
• Install the seat belt retractor and belt assembly bolt upper first.
• Make sure that seat belt height adjuster is locked in the lowest position during installation.
FRONT SEAT BELT BUCKLE
1.
Seat belt retractor and belt assembly
RH
2.
Seat belt lower anchor RH (seat belt
tension sensor)
3.
Anchor cover RH (LH similar)
4.
Seat belt lower anchor LH
5.
Seat belt anchor bracket
6.
Seat belt retractor and belt assembly
LH
7.
Center pillar
A.
Lower anchor bolt
B.
Anchor bracket bolt
C.
Retractor anchor bolt
D.
Retractor bolt upper
⇐
Vehicle front
WHIA0346E
WHIA0279E
SB-6
< ON-VEHICLE REPAIR >
SEAT BELTS
Removal
1. Remove the front seat. Refer to
SE-51, "Removal and Installation"
2. Remove the seat cushion. Refer to
SE-69, "Disassembly and Assembly"
3. Disconnect the seat belt buckle pre-tensioner electrical connector.
CAUTION:
• For removing pre-tensioner connector, insert a thin
screwdriver (1) wrapped in tape (3) into the notch. Lift the
locking tab to unlock (2), then remove the connector.
• Install the pre-tensioner connector with the locking tab
raised, then push the locking tab into the connector to
lock (4).
4. Remove screw and seat cushion inner finisher.
5. Remove the anchor bolt, then remove front seat belt buckle from
the seat frame.
Installation
Installation is in the reverse order of removal.
CAUTION:
• Front passenger seat is equipped with Occupant Classification System sensor and control module.
Do not disassemble front passenger seat cushion assembly or remove trim, this will affect the Occu-
pant Classification System calibration.
• On the passenger seat during installation, the wire harness clips must be installed in the holes they
were originally in. Do not add additional clips.
WHIA0279E
WHIA0280E
SEAT BELTS
SB-7
< ON-VEHICLE REPAIR >
C
D
E
F
G
I
J
K
L
M
A
B
SB
N
O
P
Removal and Installation of Second Row Seat Belt
INFOID:0000000005266529
SECOND ROW SEAT BELT RETRACTOR - OUTBOARD
Removal
1. Remove seat belt lower anchor cover and bolt.
2. Remove the D-ring anchor bolt cover and D-ring anchor bolt.
3. Remove the lower luggage area trim. Refer to
INT-19, "Removal and Installation"
4. Remove the seat belt guide bolt.
5. Remove seat belt retractor anchor bolt and the seat belt assembly.
1.
Seat belt height adjuster assembly
2.
D-ring anchor bolt cover
3.
D-ring anchor
4.
Seat belt retractor and belt assembly
(outboard)
5.
Seat belt buckle (outboard)
6.
Seat belt retractor cover
7.
Push pin C103
8.
Seat belt retractor and belt assembly
(center)
9.
Seat belt bezel
10. Seat belt buckle (center)
11. Seat cushion finisher
12. Seat belt lower anchor
AWHIA0221GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст