Infiniti I35 (A33). Manual — part 150
Description
NHBT0003
I
Clips and fasteners in BT section correspond to the following numbers and symbols.
I
Replace any clips and/or fasteners which are damaged during removal or installation.
Symbol No.
Shapes
Removal & Installation
C101
SBF302H
SBF367BA
C103
SBT095
SBF423H
C205
MBT080A
SBF638CA
C206
MBF519B
MBF520B
CE103
SBF104B
SBF147B
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
CLIP AND FASTENER
Description
BT-11
Symbol No.
Shapes
Removal & Installation
CF110
SBF648B
SBF649B
CF118
SBF151D
SBF259G
CR103
SBF768B
SBF770B
CS101
SBF078B
SBF992G
CLIP AND FASTENER
Description (Cont’d)
BT-12
Removal and Installation
NHBT0004
SBT862
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
BODY FRONT END
Removal and Installation
BT-13
REMOVAL
NHBT0004S02
I
When removing or installing hood, place a cloth or other padding on hood. This prevents vehicle body from
being scratched.
I
Bumper fascia is made of plastic. Do not use excessive force and be sure to keep oil away from it.
I
Hood adjustment: Adjust at hinge portion.
I
Hood lock adjustment: After adjusting, check hood lock control operation. Apply a coat of grease to hood
locks engaging mechanism.
I
Hood opener: Do not attempt to bend cable forcibly. Doing so increases effort required to unlock hood.
WARNING:
I
Be careful not to scratch hood stay when installing hood. A scratched stay may cause gas leak-
age.
I
The contents of the hood stay are under pressure. Do not take apart, puncture, apply heat or allow
fire near it.
Front Bumper Assembly
NHBT0004S0201
1. Remove clips securing engine undercover to bumper fascia.
2. Remove clips and bolts securing left and right sides of front fender protectors.
3. Remove screws and clips securing left and right sides of front fender protectors.
4. Remove clips and screws securing left and right sides of front fender protectors in wheelhouse.
5. Remove screws securing left and right front fenders to bumper fascia.
6. Remove clips securing bumper fascia.
7. Extract bumper fascia assembly, then disconnect fog lamp assembly and side marker lamp harness con-
nectors.
8. Remove energy absorber.
9. Remove bolts and hook securing headlamp assembly, then disconnect harness connectors.
10. Remove nuts securing bumper reinforcement to left and right bumper stays.
11. Extract bumper reinforcement.
12. Remove bolts and nuts securing front bumper bracket.
13. Remove bolts and nut securing bumper stays, then remove the bumper stays.
Fog lamp assembly
14. Remove bolt securing fog lamp assembly.
15. Extract fog lamp assembly.
SBT861
BODY FRONT END
Removal and Installation (Cont’d)
BT-14
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст