Mitsubishi Montero (1991+). Manual — part 190

Remove horn pad and steering wheel. See Figs. 1-6. See

STEERING COLUMN TESTING/REMOVAL & INSTALLATION table for figure

directory on specific model. Remove knee protector and upper and lower

column covers (if necessary). On Eclipse, remove hood lock release

handle and air ducts. On all models, remove any necessary cable bands,

and remove steering column switch. To install, reverse removal

procedure.

Removal (Stealth & 3000GT)

1) Disconnect negative battery cable. Wait 30 seconds, and

then remove air bag module mounting nut from back side of module. To

remove clockspring connector from air bag module, force lock outward

and pry it using a flat screwdriver. Ensure no undue force is exerted

on connector when it is removed. Remove air bag module, and store it

face up. See Fig. 7.

CAUTION: Wait at least 30 seconds after disconnecting battery cable

before continuing servicing.

2) Remove steering wheel and knee protector. Remove upper and

lower column covers. Remove air ducts. Remove right and left steering

column switches.

WARNING:DO NOT hammer on steering wheel. Collapsible steering column

mechanism may be damaged.

Installation

1) To install, reverse removal procedure. Before installing

steering wheel, center clockspring by lining up NEUTRAL mark of

clockspring with mark on steering column. To complete installation,

reverse removal procedure. DO NOT reconnect negative battery cable

until air bag module is installed.

2) After installation is complete, turn ignition on from

passenger side of vehicle. Supplemental Restraint System (SRS) light

on dash should come on for approximately 7 seconds. If SRS light does

not come on, stays on or flashes, repair air bag system.

Fig. 1: Switch Testing and R & I (Colt, Mirage & Summit)

Courtesy of Mitsubishi Motor Sales of America.

Fig. 2: Switch Testing and R & I (Colt Vista)

Courtesy of Chrysler Motors.

Fig. 3: Switch Testing and R & I (Eclipse)

Courtesy of Mitsubishi Motor Sales of America.