Mitsubishi Eclipse / Eclipse Spyder (2000-2002). Service and repair manual — part 636
![](/vehicles/winoney/isene/butrele/jud.png)
LIFTGATE
TSB Revision
BODY
42-91
LIFTGATE TRIM AND WATERPROOF FILM
REMOVAL AND INSTALLATION
M1424001400049
Required Special Tool:
•
MB990784: Remover
AC000507
4
1
5
6
3
2
4
AB
REMOVAL STEPS
1. LIFTGATE GRIP
2. LIFTGATE LOWER TRIM
3. HIGH MOUNTED STOPLIGHT LID
4. CLIP
5. LIFTGATE UPPER TRIM (LH)
6. LIFTGATE UPPER TRIM (RH)
7. LIFTGATE SIDE TRIM
REMOVAL STEPS (Continued)
![](/vehicles/winoney/isene/butrele/useainge.png)
LIFTGATE
TSB Revision
BODY
42-92
CLIP AND POSITIONS
AC000508
A
B
VIEW A
VIEW B
SECTION A – A
SECTION B – B
SECTION C – C
SECTION D – D
A
A
B
B
C
C
A
A
D
D
LIFTGATE
LOWER TRIM
LIFTGATE
UPPER TRIM (LH)
LIFTGATE
UPPER TRIM (RH)
NOTE
: CLIP POSITIONS
LIFTGATE
LOWER TRIM,
LIFTGATE
UPPER TRIM
CLIP
CLIP
LIFTGATE
UPPER TRIM
LIFTGATE
LOWER TRIM
LIFTGATE
UPPER TRIM
CLIP
LIFTGATE
UPPER TRIM (RH)
LIFTGATE
UPPER TRIM (LH)
CLIP
AB
![](/vehicles/winoney/isene/butrele/meady.png)
TRUNK LID
TSB Revision
BODY
42-93
TR U N K LID
TRUNK LID DIAGNOSIS
INTRODUCTION TO TRUNK LID DIAGNOSIS
M1421005800125
Difficult locking and unlocking and uneven clearance,
and generation of wind noise from the trunk lid may
be caused by improper adjustment of the trunk lid.
TRUNK LID DIAGNOSTIC TROUBLESHOOTING STRATEGY
M1421005900100
Use these steps to plan your diagnostic strategy. If
you follow them carefully, you will be sure that you
have exhausted most of the possible ways to find a
trunk lid fault.
1. Gather information from the customer.
2. Verify that the condition described by the
customer exists.
3. Find the malfunction by following the Symptom
Chart.
4. Verify malfunction is eliminated.
SYMPTOM CHART
M1421006000081
SYMPTOM PROCEDURES
INSPECTION PROCEDURE 1: Difficult locking and unlocking
DIAGNOSIS
STEP 1. Check the release cable routing
condition.
Q: Is the release cable routing condition good?
YES :
Go to Step 2.
NO :
Repair it, then go to Step 3.
STEP 2. Check the engagement of the trunk lid
latch and trunk lid striker.
Q: Are the trunk lid latch and trunk lid striker engaged
correctly?
YES :
Adjust it. Refer to
NO :
Then go to Step 3.
STEP 3. Check symptoms.
Q: Does the trunk lid lock operate easily?
YES :
This diagnosis is complete.
NO :
Return to Step 1.
SYMPTOMS
INSPECTION
PROCEDURE
REFERENCE PAGE
Difficult locking and unlocking
1
Uneven body clearance
2
Uneven height
3
![](/vehicles/winoney/isene/butrele/llofoso.png)
TRUNK LID
TSB Revision
BODY
42-94
INSPECTION PROCEDURE 2: Uneven body clearance
DIAGNOSIS
STEP 1. Check the trunk lid installation
condition.
Q: Is the trunk lid installation in good condition?
YES :
Adjust it. Refer to
NO :
Then go to Step 2.
STEP 2. Check symptoms.
Q: Is the clearance with the body even?
YES :
This diagnosis is complete.
NO :
Return to Step 1.
Inspection Procedure 3: Uneven height
DIAGNOSIS
STEP 1. Check the trunk lid bumper height.
Q: Is the trunk lid bumper height proper?
YES :
Adjust it. Refer to
NO :
Then go to Step2.
STEP 2. Check symptoms.
Q: Are the trunk lid and body height even?
YES :
This diagnosis is complete.
NO :
Return to Step 1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст