Defender. Manual — part 162
3.
CAUTION: Make sure area surrounding component is
clean.
Using the special tools, remove the selector rod detents.
Installation
1. NOTE: If transmission is stuck in gear, carefully manipulate
selector mechanism using a suitable flat bladed screwdriver.
Make sure all gear selector rods are aligned as shown and
the gear selector linkage is free to move.
CAUTION: Make sure area surrounding component is
2.
CAUTION: Make sure area surrounding component is
clean.
• NOTE: New selector rod detents must be seated flush with
transmission casing as necessary.
Using a suitable hammer and soft drift, install the selector
rod detents.
3. Install the transmission.
For additional information, refer to:
Transmission
(308-03
Manual Transmission/Transaxle, Installation).
Manual Transmission/Transaxle - Transmission
Removal
Special Tool(s)
Powertrain Assembly Jack
HTJ1200-02
Remover, Slider
308-652
Slide Hammer
100-012
Adapter Slide Hammer
100-012-05
Removal
1. Open the front door.
2. Remove the front seat cushion assembly.
For additional information, refer to:
Front Seat Cushion
(501-
10 Seating, Removal and Installation).
3. Remove the battery cover.
Release the clip.
4. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and
Connect
(414-01 Battery, Mounting and Cables, General
Procedures).
5. Remove centre floor console.
For additional information, refer to:
Floor Console
(501-12
Instrument Panel and Console, Removal and Installation).
6. Remove the transmission cover panel carpet.
6. Remove the transmission cover panel carpet.
7. Release the gear selector lever gaiter.
Release the gear selector lever gaitor from the
transmission tunnel.
Release the gear selector lever gaiter from the high-
low selector lever.
8.
WARNING: The gearshift lever knob will be released
suddenly, keep face clear during removal. Failure to follow
this instruction may result in personal injury.
Remove the upper gear change lever.
9. Remove the gear selector lever gaiter.
10. Disconnect the reversing lamp switch electrical connector.
11. Open bonnet for access.
12. Remove the turbocharger heat shield.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст