Defender. Manual — part 269
1. Install plastic retaining clips to rod assembly into position
and secure with 2 screws.
2. Connect control rods to latch assembly and secure with clips.
3. Install plastic retaining rod clips to mounting panel.
4. Connect control rod to push button and secure with clip.
5. Re-seal plastic sheet and install door trim panel.
For additional information, refer to:
Rear Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
![](/vehicles/onond/qug/lecmbuttig/lelirus.png)
Handles, Locks, Latches and Entry Systems - Interior Front Door Handle
Removal and Installation
Removal
1. Remove door trim casing.
For additional information, refer to:
Front Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
2. Peel back sufficient of plastic sheet to gain access to remote
lever.
3. Release spring clip and disconnect control rod from latch
mechanism.
4. Release control rod from plastic clip in mounting panel.
5. Remove 2 screws securing remote control lever to
mounting panel and withdraw lever and control rod.
Installation
1. Feed control rod into position and loosely secure lever to
mounting panel with 2 screws.
2. Connect control rod to latch mechanism and secure with
spring clip.
3. Tighten control lever retaining screws.
4. Secure control rod to plastic clip in mounting panel.
5. Secure plastic sheet.
6. Install door trim casing.
For additional information, refer to:
Front Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
![](/vehicles/onond/qug/lecmbuttig/gan.png)
Handles, Locks, Latches and Entry Systems - Hood Latch
Removal and Installation
Removal
1. Open hood.
2. Mark position of guide plate and lock to hood platform.
3. Remove 8 screws securing grille.
4. Remove grille.
5. Remove 2 bolts securing guide plate and lock.
6. Remove guide plate.
7. Release spring securing lock to hood platform.
8. Slacken clamping bolt securing hood release cable.
9. Remove lock.
Installation
1. Fit spring between lock and hood platform.
2. Position lock and guide plate to hood platform and nip up
bolts.
3. Position guide plate and lock to position marks and tighten
bolts to 10 Nm (7 lbf/ft).
4. Fit cable to lock and tighten clamping bolt.
5. Check operation of release cable and adjust if necessary.
6. Fit grille and tighten securing screws.
7. Close hood.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст