Frelander 2. Manual — part 83
![](/vehicles/onond/oloi/toor/ngllififele.png)
Rear Drive Axle/Differential - Active On-Demand Coupling Module
Removal and Installation
Removal
• NOTE: If installing a new active on-demand coupling module the sensor and throttle valve must also be installed.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise the vehicle on a lift.
1.
Disconnect the electrical connectors.
2.
3.
CAUTION: Make sure that the area around the
component is clean and free of foreign material.
Position a container to collect the fluid spillage.
Remove and discard the gasket.
3.
![](/vehicles/onond/oloi/toor/ddari.png)
Using a suitable tool, remove the throttle valve.
4.
Using a suitable tool, remove the active on
demand coupling sensor.
5.
Installation
Install the new gasket.
1.
![](/vehicles/onond/oloi/toor/quroo.png)
Install the cupped washer to the sensor with the
convex side against the sensor.
2.
3. CAUTIONS:
The throttle valve and sensor must be installed
to the active on-demand coupling module before the
assembly is installed to the active on-demand coupling.
Failure to follow this instruction may result in damage
to the vehicle.
Make sure the component is aligned as shown.
Install the sensor and washer assembly.
3.
![](/vehicles/onond/oloi/toor/lises.png)
Install the new throttle valve.
4.
5. NOTE: Lubricate the O-ring seal.
Install the active on-demand coupling module.
Torque: 6 Nm
5.
Connect the electrical connectors.
6.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст