Frelander 2. Manual — part 63
![](/vehicles/onond/oloi/toor/stousimane.png)
Rear Suspension - Rear Stabilizer Bar Link
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
3. CAUTIONS:
Make sure that the ball joint ball does not rotate.
Discard the nuts.
Torque: 60 Nm
3.
Installation
To install, reverse the removal procedure.
1.
![](/vehicles/onond/oloi/toor/yechos.png)
Rear Suspension - Wheel Knuckle
Removal and Installation
Special Tool(s)
204-159
Lever, Wheel Knuckle
204-528/2
Remover/Installer, Bushing
204-620-01
Installer, Wheel Knuckle Bushing
204-620-02
Remover/Installer, Wheel Knuckle Bushing
204-620-03
Remover, W heel Knuckle Bushing
205-725
Remover/Installer, Wheel Hub
205-726
Remover/Installer, Wheel Hub Bearing
![](/vehicles/onond/oloi/toor/zowho.png)
205-728
Remover/Installer, Wheel Hub
205-802/5
Remover, W heel Hub/Bearing
205-857
Remover, Halfshaft
LR-121
Hydraulic Cylinder 10t
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
3.
CAUTION: Do not use a hammer to detach the
halfshaft from the hub assembly, failure to follow this
instruction may result in damage to the halfshaft.
Remove and discard the rear halfshaft nut.
3.
![](/vehicles/onond/oloi/toor/tomig.png)
4.
CAUTION: Discard the nut.
• NOTE: RH illustration shown, LH is similar.
4.
Release the wheel speed sensor from the wheel
knuckle.
5.
6.
CAUTION: Make sure that no load is placed on
the brake hose.
Tie the brake caliper and brake caliper anchor
plate assembly aside.
6.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст