Jaguar XJ (X350). Manual — part 600
Thermostat - 4.2L, Vehicles With:
Supercharger (26.45.07)
Removal
WARNING: Never remove the coolant pressure cap under any circumstances while the
engine is operating. Failure to follow this instruction may result in personal injury. To avoid having
scalding hot coolant or steam blow out of the cooling system, use extreme care when removing the
coolant pressure cap from a hot cooling system. Wait until the engine has cooled, then wrap a
thick cloth around the coolant pressure cap and turn it slowly until the pressure begins to release.
Step back while the pressure is released from the system. When certain all the pressure has been
released (still with a cloth) turn and remove the coolant pressure cap from the coolant expansion
tank. Failure to follow these instructions may result in personal injury.
WARNING: To avoid the possibility of personal injury, do not operate the engine with the
hood open until the fan blades have been examined for cracks and separation. Failure to follow
this instruction may result in personal injury.
WARNING: Remove fuse 14 from the engine compartment fuse box prior to performing any
under hood service in the area of the cooling fan when the engine is hot, since the cooling fan
motor could operate if the engine has been switched OFF. Failure to follow this instruction may
result in personal injury.
CAUTION: The engine cooling system must be maintained with the correct concentration
and type of anti-freeze solution to prevent corrosion and frost damage. Failure to follow this
instruction may result in damage to the engine.
CAUTION: Never remove the coolant pressure cap under any circumstances while the
engine is operating. Failure to follow this instruction may result in damage to the engine.
1 Remove fuse 14 from the engine compartment fuse box prior to performing any under hood
.
service in the area of the cooling fan.
2 . Remove the air cleaner outlet tube.
For additional information, refer to Air Cleaner Outlet Pipe (19.10.31)
3 . Detach the thermostat housing coolant hose.
Clamp the relevant hose, to minimise coolant loss.
4 . Remove the thermostat.
Installation
1 . To install, reverse the removal procedure.
Tighten to 9 Nm.
www.
2 . Remove the coolant expansion tank bleed screw.
3
.
Fill the cooling system up to the MAX mark on the coolant expansion tank using a fifty percent
mixture of Jaguar Premium Cooling System Fluid or equivalent, meeting Jaguar specification
WSS M97B44-D and fifty percent water.
4
.
CAUTION: Do not over tighten the coolant expansion tank bleed screw. Failure to
follow this instruction may cause damage to the vehicle.
Install the coolant expansion tank bleed screw.
Tighten to 3 Nm.
5 . Install the coolant expansion tank pressure cap.
6
.
CAUTION: Do not RUN the engine with the coolant expansion tank pressure cap
removed. Failure to follow this instruction may cause damage to the vehicle.
START and RUN the engine.
7
.
SET the heating system to MAX heat, the blower motor to MAX speed and the air distribution
to instrument panel registers.
8
.
CAUTION: Observe the engine temperature gauge. If the engine starts to over-heat
switch off immediately and allow to cool. Failure to follow this instruction may cause
damage to the vehicle.
Allow the engine to RUN until hot air is emitted from the instrument panel registers, while
observing the engine temperature gauge.
9 . Switch off the engine.
10 . Allow the engine to cool.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст