Toyota Sequoia (2005). Manual — part 454
–
DIAGNOSTICS
COMBINATION METER SYSTEM
DI–1611
1805
6
Problem Symptoms Table (See page
NEXT
7
Circuit Inspection (See page
to
)
NEXT
8
Identification of Problem
NEXT
9
Repair
NEXT
10
Confirmation Test
NEXT
End
DID8S–01
/ /
/ /
COMBINATION METER SYSTEM Check Sheet
Inspector’s name:
Customer’s Name
VIN
Production Date
Licence Plate No.
Odometer Reading
km
miles
Weather Conditions
When Problem
Occurred
Frequency Problem Occurs
Weather
Outside temperature
Constantly
Sometimes ( times per day, month)
Once only
Fine
Cloudy
Rainy
Snowy
Various/Others
Hot
Warm
Cool
Cold (Approx.
°
F (
°
C))
Problem Symptom
Gauge
Malfunction in speedometer
Malfunction in tachometer
Malfunction in engine coolant temperature receiver gauge
Malfunction in fuel receiver gauge
Entire combination meter does not operate
Buzzer does not sound (Key reminder warning, Seat belt warning)
Seat belt warning for driver’s seat does not operate
Others
Operating light control rheostat does not change light brightness
Malfunction in oil pressure receiver gauge
Malfunction in volt meter
DI–1612
–
DIAGNOSTICS
COMBINATION METER SYSTEM
1806
CUSTOMER PROBLEM ANALYSIS CHECK
DID8T–01
–
DIAGNOSTICS
COMBINATION METER SYSTEM
DI–1613
1807
CUSTOMIZE PARAMETERS
HINT:
The following can be customized.
NOTICE:
After confirming whether the items of the customer’s request are applicable or not as custom-
ized items, perform customization.
Be sure to record the current value before customizing.
When troubleshooting, pay attention as there is a possibility that the function has been set to
SMALL through customizing (Example: In case of the symptom in which ”The key reminder
buzzer operation does not function” is displayed, check that the key reminder buzzer operation
is not set to SMALL, then perform troubleshooting).
METER:
DISPLAY (ITEM)
DEFAULT
CONTENTS
SETTING
KEY REMND VOLUM
(Key reminder buzzer vol-
ume)
LARGE
Function that changes the volume of key reminder buzzer.
LARGE/MEDIUM/SMALL
DID8U–01
DI–1614
–
DIAGNOSTICS
COMBINATION METER SYSTEM
1808
PROBLEM SYMPTOMS TABLE
HINT:
Inspect the related ”Fuse” and ”Relay” before confirming the suspected area as shown in the table below.
MALFUNCTION SYSTEM:
Symptom
Suspected Area
See page
Entire combination meter does not operate.
Refer to troubleshooting procedures
Operating light control rheostat does not change light brightness.
Refer to troubleshooting procedures
Seat belt warning does not operate.
Refer to troubleshooting procedures
Key reminder warning buzzer does not sound.
1. Multiplex communication system
2. Key unlock warning switch circuit
3. Door courtesy lamp switch circuit
4. Combination meter assy
METER GAUGES:
Symptom
Suspected Area
See page
Malfunction in speedometer
Refer to troubleshooting procedures
Malfunction in tachometer
Refer to troubleshooting procedures
Malfunction in fuel receiver gauge
Refer to troubleshooting procedures
Malfunction in engine coolant temperature receiver gauge
Refer to troubleshooting procedures
Malfunction in oil pressure receiver gauge
Refer to troubleshooting procedures
Malfunction in volt meter
Refer to troubleshooting procedures
WARNING LIGHTS:
Symptom
Suspected Area
See page
Check engine warning light (MIL) does not come on.
1. ECM
2. Wire harness or connector
3. Combination meter assy
–
Discharge warning light does not come on.
1. ECM
2. Wire harness or connector
3. Combination meter assy
–
Brake warning light does not come on.
1. Skid control ECU
2. Wire harness or connector
3. Combination meter assy
–
ABS warning light does not come on.
1. Skid control ECU
2. Wire harness or connector
3. Combination meter assy
–
SRS warning light does not come on.
1. Airbag sensor assy
2. Wire harness or connector
3. Combination meter assy
–
Open door warning light does not come on.
1. Door courtesy light switch circuit
2. Wire harness or connector
3. Combination meter assy
4. Body ECU
–
Fuel level warning light does not come on.
1. Refer to troubleshooting
2. Wire harness or connector
3. Combination meter assy
–
Low oil pressure warning light does not come on.
1. Low oil pressure warning switch
2. Wire harness or connector
3. Combination meter assy
–
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст