Toyota Sequoia (2005). Manual — part 740
![](/vehicles/linovind/vere/fry/vep.png)
F19247
F19248
F19249
F19250
F19251
–
TRANSFER
TRANSFER ASSEMBLY
TR–11
2949
(c)
Using a magnetic finger, remove the 2 shift inter–lock
pins.
11.
REMOVE FRONT NO. 2 STOPPER SHIFT SHAFT
12.
REMOVE REAR OUTPUT SHAFT ASSEMBLY, GEAR
SHIFT FORK NO. 1, FRONT DRIVE CHAIN AND DRIV-
EN SPROCKET
(a)
Using 2 screwdrivers and a hammer, tap out the snap
ring.
(b)
Using 2 screwdrivers and a hammer, tap out the snap
ring.
(c)
Using a snap ring expander, remove the snap ring.
(d)
Mount the transfer case rear in a vise.
(e)
Using a plastic hammer, carefully tap the transfer case
rear, and remove the rear output shaft assembly together
with the gear shift fork No. 1, front drive chain and driven
sprocket.
![](/vehicles/linovind/vere/fry/ither.png)
F19253
F19256
F19257
F19258
F19259
TR–12
–
TRANSFER
TRANSFER ASSEMBLY
2950
13.
REMOVE REAR NO. 2 STOPPER TRANSFER SHIFT
SHAFT
14.
REMOVE TRANSFER SHIFT ACTUATOR
(a)
Using 2 screwdrivers and a hammer, tap out the snap
ring.
(b)
Remove the 3 bolts and transfer shift actuator.
15.
REMOVE OIL SEPARATOR
(a)
Remove the 3 bolts and oil separator.
(b)
Remove the magnet from the transfer front case.
16.
REMOVE OIL PUMP
(a)
Remove the 3 bolts and oil pump.
![](/vehicles/linovind/vere/fry/echen.png)
F19260
F19261
F19262
F19263
F19264
–
TRANSFER
TRANSFER ASSEMBLY
TR–13
2951
(b)
Using a screwdriver, remove the O–ring from the oil
pump.
NOTICE:
Be careful not to damage the oil pump.
17.
REMOVE OIL PUMP GEAR
18.
REMOVE LOW PLANETARY GEAR WITH INPUT
SHAFT
(a)
Using a snap ring expander, remove the snap ring.
(b)
Remove the low planetary gear with the input shaft from
the transfer front case.
(c)
Remove the spacer and output shaft front needle roller
bearing from the input shaft.
(d)
Using a screwdriver and hammer, remove the oil seal
from the transfer front case.
![](/vehicles/linovind/vere/fry/jur.png)
F19265
F19266
F19267
Front
F19289
F19290
TR–14
–
TRANSFER
TRANSFER ASSEMBLY
2952
19.
REMOVE LOW PLANETARY GEAR
(a)
Using a snap ring expander, remove the snap ring.
(b)
Remove the input gear stopper, ball and planetary carrier
washer.
(c)
Remove the input shaft from the low planetary gear.
(d)
Remove the thrust bearing race No. 1 and low planetary
gear bearing.
20.
REMOVE CASE PLUG
Remove the case plug, compression spring and head pin from
the transfer front case.
21.
REMOVE LOW PLANETARY RING GEAR
(a)
Using a screwdriver, remove the snap ring.
NOTICE:
Be careful not to damage the transfer front case.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст