Toyota Sequoia (2005). Manual — part 794
SA2D3–01
F16835
Matchmarks
F16836
–
SUSPENSION AND AXLE
REAR HEIGHT CONTROL SENSOR
SA–169
3165
REMOVAL
1.
DISCONNECT CONNECTOR
2.
DISCONNECT HEIGHT CONTROL SENSOR LINK
(a)
Put matchmarks on the height control sensor link and
bracket.
(b)
Remove the nut and disconnect the sensor link.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
3.
REMOVE REAR HEIGHT CONTROL SENSOR
(a)
Disconnect the wire harness clamp.
(b)
Remove the 2 bolts and rear height control sensor.
Torque: 29 N·m (300 kgf·cm, 21 ft·lbf)
SA1IB–03
SA–170
–
SUSPENSION AND AXLE
REAR HEIGHT CONTROL SENSOR
3166
INSTALLATION
Installation is in the reverse order of removal (See page
).
SA2CW–01
F16828
F16828
–
SUSPENSION AND AXLE
SUSPENSION CONTROL ECU
SA–171
3167
SUSPENSION CONTROL ECU
REPLACEMENT
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE INTEGRATION CONTROL PANEL
(See page
3.
REMOVE SUSPENSION CONTROL ECU
(a)
Disconnect the connector.
(b)
Remove the screw and suspension control ECU.
4.
INSTALL SUSPENSION CONTROL ECU
(a)
Install the suspension control ECU with the screw.
(b)
Connect the connector.
5.
INSTALL INTEGRATION CONTROL PANEL
(See page
6.
CONNECT CABLE TO NEGATIVE BATTERY TERMI-
NAL
7.
PERFORM INITIALIZATION (See page
)
Some systems need initialization when disconnecting the cable
from the negative battery terminal.
BR0A9–04
–
BRAKE
BRAKE SYSTEM
BR–1
3168
BRAKE SYSTEM
PRECAUTION
Care must be taken to replace each part properly as it could affect the performance of the brake
system and result in a driving hazard. Replace the parts with parts having the same part number
or equivalent.
It is very important to keep parts and the area clean when repairing the brake system.
If the vehicle is equipped with a mobile communication system, refer to the precautions in the
IN section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст