Toyota Sequoia (2005). Manual — part 792
SA0L1–06
F16846
N·m (kgf·cm, ft·lbf) : Specified torque
Non–reusable part
Height Control Filter
Bracket
Rear Bumper
Holder
Bushing
O–Rings
5.9 (60, 52 in.·lbf)
Height Control Compressor
and Dryer
6.4 (65, 57 in.·lbf)
Height Control Compressor
Hose
Clip
Clip
Clip
Clip
29 (300, 21)
29 (300, 21)
Clip
Height Control Tube
MP grease
Bushing
Compressor Cover
–
SUSPENSION AND AXLE
HEIGHT CONTROL COMPRESSOR AND DRYER
SA–161
3157
HEIGHT CONTROL COMPRESSOR AND DRYER
COMPONENTS
SA2D1–01
F16829
F16830
SA–162
–
SUSPENSION AND AXLE
HEIGHT CONTROL COMPRESSOR AND DRYER
3158
REMOVAL
1.
REMOVE REAR BUMPER (See page
)
2.
DISCONNECT HEIGHT CONTROL TUBE
(a)
Remove the holder.
(b)
Spread the clip and slowly pull the height control tube
straight out.
NOTICE:
Do not remove the clip from the union except when replac-
ing it.
(c)
Remove the O–ring.
HINT:
Perform the following before installation:
Coat a new O–ring with MP grease.
Push the air tube in straight to connect it until the clip
makes a ”clicking” sound.
3.
REMOVE HEIGHT CONTROL COMPRESSOR AND
DRYER
HINT:
Check for leakage after installation (See page
(a)
Separate the hose from the compressor cover.
(b)
Remove the 3 clips and compressor cover.
(c)
Remove the hose.
(d)
Disconnect the wire harness from the clamp.
(e)
Remove the 3 bolts and height control compressor and
dryer.
Torque: 29 N·m (300 kgf·cm, 21 ft·lbf)
(f)
Disconnect the 3 wire harness clamps and hose.
F16831
–
SUSPENSION AND AXLE
HEIGHT CONTROL COMPRESSOR AND DRYER
SA–163
3159
(g)
Remove the 3 bolts, bushing and the bracket from the
height control compressor.
Torque: 5.9 N·m (60 kgf·cm, 52 in.·lbf)
(h)
Remove the 2 bolts and the filter from the height control
compressor.
Torque: 6.4 N·m (65 kgf·cm, 56 in.·lbf)
SA0L3–03
SA–164
–
SUSPENSION AND AXLE
HEIGHT CONTROL COMPRESSOR AND DRYER
3160
INSTALLATION
Installation is in the reverse order of removal (See page
).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст