Toyota Sequoia (2005). Manual — part 828
H01584
Slider
Disconnection is completed
Slider
H01585
Slider
Slider
RS–18
–
SUPPLEMENTAL RESTRAINT SYSTEM
SRS AIRBAG
3301
24.
DISCONNECTION OF CONNECTOR FOR SIDE AIRBAG ASSEMBLY
(a)
Place a finger on the slider, slide the slider to release the lock, and then disconnect the connector.
25.
CONNECTION OF CONNECTOR FOR SIDE AIRBAG ASSEMBLY
(a)
Connect the connector as shown in the illustration. (When locking, make sure that the slider returns
to its original position and a click sound can be heard.)
HINT:
When connecting, the slider will slide. Be sure not to touch the slider while connecting, as it may result in
an insecure fit.
H02763
Outer
H02764
Lock of connector is released
Disconnection is completed
H02768
Outer
Outer
Connection is completed
–
SUPPLEMENTAL RESTRAINT SYSTEM
SRS AIRBAG
RS–19
3302
26.
DISCONNECTION OF CONNECTORS FOR SIDE AIR-
BAG SENSOR AND CURTAIN SHIELD AIRBAG SEN-
SOR
(a)
While holding both outer flank sides, slide the outer in the
direction shown by the arrow.
(b)
When the connector lock is released, the connectors are
disconnected.
HINT:
Be sure to hold both outer flank sides. Holding the top and bot-
tom sides will make disconnection difficult.
27.
CONNECTION OF CONNECTORS FOR SIDE AIRBAG SENSOR AND CURTAIN SHIELD AIRBAG
SENSOR
(a)
Connect the connector as shown in the illustration. (When locking, make sure that the outer returns
to its original position and a click sound can be heard.)
HINT:
When connecting, the outer will slide. Be sure not to hold the outer while connecting, as it may result in an
insecure fit.
RS0B8–15
H23200
Spiral Cable
Steering Column Cover Lower
Steering Wheel Pad
N·m (kgf·cm, ft·lbf) : Specified torque
Steering Wheel
Steering Wheel Cover Lower No. 2
Steering Wheel Cover Lower No. 3
8.8 (90, 78 in.·lbf)
8.8 (90, 78 in.·lbf)
Torx
®
Screw
Torx
®
Screw
RS–20
–
SUPPLEMENTAL RESTRAINT SYSTEM
STEERING WHEEL PAD AND SPIRAL CABLE
3303
STEERING WHEEL PAD AND SPIRAL CABLE
COMPONENTS
RS0B9–13
–
SUPPLEMENTAL RESTRAINT SYSTEM
STEERING WHEEL PAD AND SPIRAL CABLE
RS–21
3304
REMOVAL
NOTICE:
If the wiring connector of the SRS is disconnected and the ignition switch is in the ON or ACC
position, DTCs will be recorded.
Never use airbag parts from another vehicle. When replacing parts, replace them with new
ones.
1.
PRECAUTION (SEE PAGE
)
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3.
REMOVE STEERING WHEEL PAD (SEE PAGE
)
4.
REMOVE STEERING WHEEL (SEE PAGE
)
5.
REMOVE STEERING COLUMN COVER LOWER (SEE PAGE
6.
REMOVE SPIRAL CABLE (SEE PAGE
)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст