Toyota Sequoia (2005). Manual — part 826
H23862
Lance
Retainer
Holder
Retainer
1
2
H23916
A
A
Lever
RS–10
–
SUPPLEMENTAL RESTRAINT SYSTEM
SRS AIRBAG
3293
(5)
Connector lock mechanism (2):
Both the primary lock with holder lances and the
secondary lock with retainer prevent the connectors
from becoming disconnected.
(6)
Improper connection prevention lock mechanism:
When connecting the holder, the lever is pushed
into the end by rotating around the A axis to lock the
holder securely.
H23907
(a)
(b)
Lock Button
(Yellow Part)
Lock Button
(Yellow Part)
H23908
Lock Button
(Yellow Part)
–
SUPPLEMENTAL RESTRAINT SYSTEM
SRS AIRBAG
RS–11
3294
16.
DISCONNECTION OF CONNECTORS FOR STEERING WHEEL PAD AND CURTAIN SHIELD AIR-
BAG ASSEMBLY
(a)
Release the lock button (yellow part) of the connector using a screwdriver.
(b)
Insert the screwdriver tip between the connector and the base, and then raise the connector.
17.
CONNECTION OF CONNECTORS FOR STEERING WHEEL PAD AND CURTAIN SHIELD AIRBAG
ASSEMBLY
(a)
Connect the connector.
(b)
Push down securely on the lock button (yellow part) of the connector. (When locking, a click sound can
be heard.)
H01586
Slider
Slider
Disconnection is completed
H01587
Slider
Connection is completed
Slider
RS–12
–
SUPPLEMENTAL RESTRAINT SYSTEM
SRS AIRBAG
3295
18.
DISCONNECTION OF FRONT PASSENGNR AIRBAG ASSEMBLY
(a)
Place a finger on the slider, slide the slider to release the lock, and then disconnect the connector.
19.
CONNECTION OF FRONT PASSENGNR AIRBAG ASSEMBLY
(a)
Connect the connector as shown in the illustration. (When locking, make sure that the slider returns
to its original position and a click sound can be heard.)
HINT:
When connecting, the slider will slide. Be sure not to touch the slider while connecting, as it may result in
an insecure fit.
H23909
A
Disconnection is completed
Holder (with connectors)
H23910
Retainer
–
SUPPLEMENTAL RESTRAINT SYSTEM
SRS AIRBAG
RS–13
3296
20.
DISCONNECTION OF CONNECTOR FOR AIRBAG SENSOR ASSY CENTER
(a)
Pull the lever by pushing part A as shown in the illustration and disconnect the holder (with connectors).
HINT:
Perform the following procedures when replacing the holder.
(b)
Remove the holder.
(1)
Using a screwdriver, unlock the retainer.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст