Toyota Sequoia (2005). Manual — part 316
![](/vehicles/linovind/vere/fry/yowhe.png)
F13441
–
DIAGNOSTICS
ABS WITH EBD & BA & TRAC & VSC SYSTEM
DI–1059
1253
Check for Fluid Leakage
Check actuators or hydraulic lines for fluid leakage.
DI94C–03
![](/vehicles/linovind/vere/fry/anntad.png)
DIDHX–01
F17795
F19734
Bypass Wire
F17797
Tester Probe
DI–1060
–
DIAGNOSTICS
CAN COMMUNICATION SYSTEM
1254
CAN COMMUNICATION SYSTEM
PRECAUTION
1.
BUS LINE REPAIR
(a)
After repairing the bus line with solder, wrap the repaired
part with vinyl tape.
NOTICE:
The CANL bus line and CANH bus line must be
installed together all the time.
When installing, make sure to twist them.
CAN bus lines are likely to be influenced by noise if
the bus lines are not twisted.
The difference in length of the CANL bus line and
CANH bus line should be within 100 mm (3.937 in.).
Leave approximately 80 mm (3.150 in.) loose in the
twist around the connector.
(b)
Do not use a bypass wire between the connectors.
NOTICE:
The feature of the twisted wire harness will be lost if you
use a bypass wire.
2.
CONNECTOR HANDLING
(a)
When inserting tester probes into a connector, insert them
from the rear of the connector.
![](/vehicles/linovind/vere/fry/veanof.png)
F17798
Repair Wire
–
DIAGNOSTICS
CAN COMMUNICATION SYSTEM
DI–1061
1255
(b)
If it is impossible to check continuity from the rear of the
connector, then use a repair wire to check the connector.
3.
PRECAUTION FOR DISCONNECTING THE BATTERY CABLE
NOTICE:
When disconnecting the battery terminal, initialize the following system after the terminal is recon-
nected.
System Name
See Page
Back Door Power Window Control System
![](/vehicles/linovind/vere/fry/mayb.png)
DIDHY–01
F19696
Junction Connector
Suspension
Control ECU
Translate ECU
ECM
DLC3
DI–1062
–
DIAGNOSTICS
CAN COMMUNICATION SYSTEM
1256
LOCATION
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст