Toyota Sequoia (2005). Manual — part 773
![](/vehicles/linovind/vere/fry/ndrinsaus.png)
SA243–03
W03080
–
SUSPENSION AND AXLE
FRONT LOWER BALL JOINT
SA–85
3081
FRONT LOWER BALL JOINT
ON–VEHICLE INSPECTION
INSPECT LOWER BALL JOINT EXCESSIVE PLAY ON–VE-
HICLE
(a)
Remove the front wheel and install the hub nuts to the
disc.
(b)
Using a dial indicator, check the lower ball joint for exces-
sive play when you push the hub nuts up and down with
a force of 294 N (30 kgf, 66 lbf).
Maximum: 0.5 mm (0.020 in.)
![](/vehicles/linovind/vere/fry/vieenda.png)
SA244–06
F07280
N·m (kgf·cm, ft·lbf)
: Specified torque
Non–reusable part
Tie Rod End
Cotter Pin
Lower Suspension Arm
Lower Ball Joint
Cotter Pin
91 (930, 67)
65 (663, 48)
159 (1,621, 117)
SA–86
–
SUSPENSION AND AXLE
FRONT LOWER BALL JOINT
3082
COMPONENTS
![](/vehicles/linovind/vere/fry/per.png)
SA245–05
R13300
R13425
SST
R12863
SST
–
SUSPENSION AND AXLE
FRONT LOWER BALL JOINT
SA–87
3083
REMOVAL
1.
REMOVE FRONT WHEEL
2.
LOOSEN 4 LOWER BALL JOINT SET BOLTS
HINT:
Do not remove the bolts.
3.
DISCONNECT TIE ROD END
(a)
Remove the cotter pin and nut from the tie rod end.
(b)
Using SST, disconnect the tie rod end from the lower ball
joint.
SST
09610–20012
4.
REMOVE LOWER BALL JOINT
(a)
Remove the cotter pin and nut from the lower ball joint.
(b)
Using SST, disconnect the lower ball joint from the lower
suspension arm.
SST
09628–62011
(c)
Remove the 4 lower ball joint set bolts.
(d)
While lifting the upper suspension arm and steering
knuckle, remove the lower ball joint.
(e)
Support the upper suspension arm and steering knuckle
securely.
![](/vehicles/linovind/vere/fry/nsifis.png)
SA246–04
R12777
SA–88
–
SUSPENSION AND AXLE
FRONT LOWER BALL JOINT
3084
INSPECTION
1.
INSPECT LOWER BALL JOINT BOOT FOR DAMAGE
2.
INSPECT LOWER BALL JOINT FOR ROTATION
CONDITION
(a)
As shown in the illustration, flip the ball joint stud back and
forth 5 times before installing the nut.
(b)
Using a torque wrench, turn the nut continuously 1 turn
per 3 to 5 seconds and take the torque reading on the 5th
turn.
Turning torque:
1.0 – 6.5 N·m (10 – 66 kgf·cm, 9 – 56 in.·lbf)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст