Toyota Sequoia (2005). Manual — part 875
Perform any of the following and the system will go to disarmed state (B):
Turn the key from IG to OFF and remove the key from the ignition, open the driver’s door.
Disarmed state (A)
Perform any of the following and the system
will return to disarmed state (A):
Push the unlock switch on the transmitter.
Put the key in the key cylinder.
Reconnect the battery.
Turn the ignition from OFF to ON.
Unlock any of the doors or back door with
the key.
Disarmed state (B)
Perform the following and the system will go
to arming preparation:
Close all the doors, hood and
back door.
Perform any of the following
and the system
will return to disarmed state
(B):
Open any of the doors, the
hood or the back door.
Arming preparation
Perform the following and the
system will go to armed state:
Allow 30 seconds to elapse
with all the doors, hood and
back door closed.
Perform any of the following and
the system
will return to disarmed state (A):
Push the unlock switch on the
transmitter.
Put the key in the ignition.
Reconnect the battery.
Turn the ignition from OFF to
ON.
Unlock any of the doors or back
door with the key.
–
BODY ELECTRICAL
THEFT DETERRENT SYSTEM
BE–85
3489
3.
PASSIVE ARMING MODE
This mode can be switched by the C–BEST customizing
function (See page
).
All modes are initially set to active when shipped from fac-
tory (no passive mode).
Perform the following and the system will return
to armed state:
Allow the alarm sounding period to pass.
Alarm sounding
Perform any of the following and the system will
return to disarmed state (A):
Push the unlock switch on the transmitter.
Put the key in the key cylinder and turn it ON.
Unlock any of the doors or the back door
with the key.
Perform any of the following and the system will
return to disarmed state (A): *
Push the unlock switch on the transmitter.
Put the key in the key cylinder and turn it ON.
Unlock any of the doors or the back door
with the key.
Armed state
Perform and/or detect any of the following
and the system will go on to alarm sounding:
Open any of the doors or the back door and
allow the entry delay time to pass.
Open the hood.
Reconnect the battery.
Ignition switch is connected directly.
Broken window glass.
BE–86
–
BODY ELECTRICAL
THEFT DETERRENT SYSTEM
3490
Door
Indicator
Alarming output
System condition
Armed state
Alarm
sounding
Entry delay time
Close
Open
ON
OFF
ON
OFF
–
BODY ELECTRICAL
THEFT DETERRENT SYSTEM
BE–87
3491
HINT:
If any door is opened in the armed state, entry delay will occur
for 14 seconds.
During this time, the mode transfers to disarmed state if the
condition * is met.
When the condition is not met, the system judges that theft oc-
curs and transfers to the alarm sounding state.
BE–88
–
BODY ELECTRICAL
THEFT DETERRENT SYSTEM
3492
Indicator light output:
Condition
Indicator light
Disarmed state
OFF
Arming preparation
ON
Armed state
(Entry delay time)
OFF
(ON)
Alarm sounding
ON
HINT:
Even in the disarmed state, the indicator light blinks. (Due to the
signal output from the immobilizer system). The indicator al-
ways blinks receiving the signal from the immobilizer system
any time in the arming condition.
Blinking frequency:
0.2 seconds (ON)
1.8 seconds (OFF)
(a)
Transfer to active mode:
In each passive mode, when ”disarmed state of active
mode
→
arming preparation transfer condition” is met, the
active mode transfers to each condition. In this case, ac-
tive mode continues till it becomes disarmed state.
Passive mode when transfer condition is
met.
Active mode transfer condition
Disarmed state
Arming preparation condition
Arming preparation condition
Arming preparation condition
Armed state
(During entry delay time)
Arming condition
(After alarming time has elapsed, arming
condition)
Alarm sounding
After alarming time has elapsed, arming
condition
(b)
Answer back:
The buzzer and taillights respond as answer back under
the following conditions.
(1)
When the system is set:
Arming preparation is set from disarmed state using
the wireless door lock, the buzzer and taillights.
(2)
When the system is released:
Disarmed state is set from either arming prepara-
tion, armed state or alarm sounding using the wire-
less door lock, the buzzer and taillights.
4.
PANIC ALARM CONTROL
(a)
The panic alarm control makes it possible for you to volun-
tarily set off the panic alarm by pressing the PANIC switch
on the wireless transmitter. However, this control oper-
ates independently from the alarm control by the theft de-
terrent system (switched to the alarm sounding state from
the armed state).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст