Kia Carnival (2007 year). Manual — part 104

Inhibiter Switch

2007 > 2.7L V6 GASOLINE >

DESCRIPTION

Inhibitor Switch

- Type: Rotary contact type
- Range of temperature : -40°C~145°C(-40°F~293°F)

Inhibitor Switch - Continuity check(Sports mode)

2007 > 2.7L V6 GASOLINE >

REPLACEMENT

1. Pull up the parking brake.

2. Position the shift lever in 'N' range.

3. Remove the air cleaner assembly.

4. Remove the battery.

5. Remove the battery tray.

6. Remove the inhibiter switch connector.

7. Remove the shift cable mounting nut(A).

8. Remove the inhibiter switch loosening the mounting bolts.

9. Refering to 'INSPECTION', check for continuity. If there is an error, replace the inhibiter switch.

10. After tightening the shift cable mounting nut, connect the inhibiter switch.

11. Install the battery, battery tray and the air cleaner assembly.

INSPECTION

1. Check for the starter motor when the ignition switch is at 'START' position and the shift lever at 'P' or 'N' range.

2. Check for the rear lamp when the ignition switch if it does not work properly.

3. Check for the inhibiter switch if it does not work properly.

4. If the inhibiter switch is not fixed in a proper position, reassemble it in the right position.

5. Re-check 1 and 2 procedures.

6. Using a scan tool, confirm the DTCs.

7. Disconnect the battery (-) terminal and the inhibiter switch.

8. Check for continuity between terminals at the switch connector.

9. If there is not continuity between the terminals in the table above for each switch position, replace the inhibiter

switch.

ADJUSTMENT

1. Set the select lever to the "N" position.

2. Loosen the control cable to manual control lever coupling nut to free the cable and lever.

3. Set the manual control lever to the neutral position.

4. Loosen the transaxle range switch body mounting bolts and then turn the transaxle range switch body so the hole

in the end of the manual control lever and the hole (cross section A-A in the figure) in the flange of the transaxle
range switch body flange are aligned.

5. Tighten the transaxle range switch body mounting bolts to the specified torque. Make sure at this time that the

position of the switch body did not move.

TORQUE :
10~12Nm (1.0~1.2kgf.m, 7~8lb-ft)