Daewoo Musso. Manual — part 190
![](/vehicles/epme/qux/oho/yong.png)
1F3-40 OM600 ENGINE CONTROLS
Start of Delivery (RIV)
Idle Speed
(Connection Diagram for Testers With Adapter)
1 Fuel Injection Pump
2 Rl Sensor
3 Digital Tester
4 TDC Pulse Sender Unit
5 Battery
6 Rl Pulse Generator
Service Data
ATDC 14° - 16°
OM661LA : 720 - 820 rpm, OM662LA : 750 - 850 rpm
![](/vehicles/epme/qux/oho/ili.png)
OM600 ENGINE CONTROLS 1F3-41
With Pulse Generator
Tools Required
617 589 09 21 00 Rl Sensor
617 589 10 21 00 Timing Tester
667 589 00 21 00 TDC Pulse Generator
Commercial Tools
Item
Digital Tester
Without Pulse Generator
Tools
Bosch, MOT 001.03
Hartmann & Braun, EOMT3
Bosch, ETD 019.00
Sun, DIT 9000
ALV, Diesel - Tester 875
Test Procedure
1. Remove the screw plug (7) and seal (8) collect oil in a suitable
vessel.
2. Install the Rl sensor into the governor housing of injection
pump (1).
Rl Sensor 617 589 10 21 00
3. Connect the digital tester and TDC pulse sender unit
according to connection diagram.
4. Run the engine at idle speed and check the Rl value on the
digital tester
Notice
If out of standard, adjust the start of delivery.
5. Stop the engine.
6. Remove the Rl sensor, digital tester and TDC pulse sender
unit.
7. Replace the seal and tighten the plug.
8. Check engine oil level and adjust if necessary.
Rl value
ATDC 14° - 16°
Tightening Torque
30 Nm
![](/vehicles/epme/qux/oho/hing.png)
1F3-42 OM600 ENGINE CONTROLS
After Testing
Preceding Work : Start of delivery test
Position Sensor (RIV method)
1 Adjusting Screw
2 Bolt . . . . . . . . . . . . . . . 23Nm
3 Fuel Injection Pump
4 Bolt . . . . . . . . . . . . . . . 23Nm
5 Scale . . .. Rl start of delivery = 14° - 16° ATDC
![](/vehicles/epme/qux/oho/winisera.png)
OM600 ENGINE CONTROLS 1F3-43
Tools Required
617 589 08 21 00 Position Sensor
Adjustment Procedure
1. Position the No. 1 cylinder at ATDC 15°
Notice
Do not rotate the engine in opposite direction of engine
rotation.
2. Remove the bolt (2) at the supporting bracket.
3. Remove the bolt (4).
4. Turn the adjusting screw (1) until both lamps ‘A’ + ‘B’ on
the position sensor light up.
Notice
If the adjustment range is not adequate, remove the injection
pump and reinstall.
Position Sensor 617 589 08 21 00
5. After adjusting, retighten all the bolt to the specified torque.
To the right
To the left
Start of delivery retarded
Start of delivery advanced
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст