Daewoo Musso. Manual — part 188
1F3-32 OM600 ENGINE CONTROLS
5. Remove the plug (6) and seal (5) from the fuel injection
pump and collect oil in a suitable vessel.
Installation Notice
Notice
Replace the seal.
Tightening Torque
30 Nm
6. Install the locking screw (18) into the injection pump.
Notice
Before tightening the bolts for the injection timing device
and the camshaft sprocket, always remove the locking screw
from the injection pump and reinstall the plug.
Locking Screw 601 589 05 21 00
7. Place alignment marks (arrow) on the timing chain (12) and
camshaft sprocket (15).
4. Position the no.1 cylinder at ATDC 15°.
Notice
Do not rotate the engine with camshaft sprocket bolt or
opposite direction of the engine rotation.
OM600 ENGINE CONTROLS 1F3-33
9. Pull out the 12-sided stretch bolt (14) and washer and
remove the camshaft sprocket (12).
Tightening Torque
46 Nm
11. Using special tool (24, 25), remove the locking pin (8).
Sliding Hammer 116 589 20 33 00
Threaded Bolt 116 589 02 34 00
8. Remove the chain tensioner (17).
Installation Notice
Tightening Torque
80 Nm
Notice
Replace the seal (16).
10. Pull out the bolt (11) and washer (10).
Notice
Be careful that the bolt is left-hand thread.
Installation Notice
1F3-34 OM600 ENGINE CONTROLS
12. Push back the timing chain with retaining plate (26) and
remove the injection timing device (9).
Retaining Plate 667 589 04 63 00
13. Installation should follow the removal procedure in the
reverse order.
14. After assembling the engine, check start of delivery and
adjust if necessary.
OM600 ENGINE CONTROLS 1F3-35
INJECTION TIMING DEVICE
Preceding Work : Removal of injection timing device
1 Cam Sprocket . . . . . . . . . . ... Check
2 Bushing . . . . . . . . . . . . . Check
3 Governor Weights
4 Segment Flange and Drive Hub
5 Compression Springs
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст