Daewoo Musso. Manual — part 108
![](/vehicles/epme/qux/oho/jui.png)
OM600 ENGINE MECHANICAL 1B3-139
CAMSHAFT
Preceding Work : Removal of cylinder head cover
1 Bolt . . . . . . . . . . . . . . . 25Nm
2 Washer
3 Camshaft Bearing Cap
4 Camshaft
5 Dowel Pin
6 Locking Washer
7 Timing Chain
8 Cylinder Head
9 Oil Pan
10 Camshaft Sprocket
11 Washer
12 12-Sided Bolt (M11) . . . . Check, 25Nm + 90°
13 Gasket . . . . . . . . . . . . ... Replace
14 Chain Tensioner . . . . . . . . . . 80Nm
![](/vehicles/epme/qux/oho/tst.png)
1B3-140 OM600 ENGINE MECHANICAL
3. Remove the starter motor and install the engine lock.
Engine Lock 602 589 00 40 00
Tools Required
602 589 00 40 00 Engine Lock
Removal Procedure
1. Rotate the crankshaft and position the piston of no.1 cylinder
at TDC.
Notice
Do not rotate the crankshaft in the opposite direction of
engine rotation.
In this position, the markings of the camshaft/camshaft
bearing cap (arrow) must be aligned.
2. Place alignment marks on the camshaft sprocket and timing
chain.
![](/vehicles/epme/qux/oho/ssomoure.png)
OM600 ENGINE MECHANICAL 1B3-141
4. Remove the bolt and then remove the camshaft sprocket.
Notice
During removal, be careful not to drop the sprocket with
chain. Remove the chain carefully and then pull out the
sprocket.
5. Remove the chain tensioner.
6. Remove the camshaft bearing cap bolts according to the
removal order.
Notice
Remove the camshaft bearing cap bolts of 1(dark arrow)
first and then remove the bolts of 2 (light arrow) one
revolution in stages until the counter-pressure is released.
In order to avoid damaging the camshaft, it is essential to
adhere to the removal order for the camshaft bearing caps.
OM 662LA
OM 661LA
![](/vehicles/epme/qux/oho/fan.png)
1B3-142 OM600 ENGINE MECHANICAL
4. Install the camshaft bearing caps according to markings(1,
2, 3 etc.).
7. Remove the camshaft bearing cap.
8. Pull off the camshaft.
Notice
Be careful not to miss front locking washer.
9. Pull out the locking washer.
Notice
Check the condition of locking washer and replace if
necessary.
Installation Procedure
1. Insert the locking washer.
2. Check the valve tappet and ensure that tappet moves
smoothly.
3. Coat the camshaft with oil and install the camshaft onto the
cylinder head so that the TDC marking (arrow) is positioned
upward vertically.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст