Dacia Solenza (engine E7J). Manual — part 167

87

ELECTRICAL ASSISANCE EQUIPEMENT

87 - 28

Diagnostic – Damage location algorithm

ALP 2

Turning lights not working

RECOMMENDATIONS

Do not consult these information but before a complete
checking by means of the CLIP tester.
Check the bulbs

Check the condition of fuse F13 (25A) and replace it if necessary.

Push the hazard switch and check that state <<ET291 hazard lights information>> is
ACTIVE; if not, refer to chapter dealing with this state.
Act upon the right or left turning lights and check that state right turning information ET309 and
state left turning information ET310 are ACTIVE, if not, refer to the corresponding chapter of
these states.

Check the condition of connector P1 with 15 pins of Cockpit Central Unit
Replace it if necessary.

Ensure continuity of connections :

UCH connector P1 pin A9

left turning lamp

UCH connector P1 pin A8

right turning lamp

Fix if necessary.

Check the system operation

AFTER REPAIRING

87

ELECTRICAL ASSISANCE EQUIPEMENT

87 - 29

Diagnostic – Damage location algorithm

RECOMMENDATIONS

Do not consult these information but before a complete
checking by means of the CLIP tester.
Check the bulbs

Check the condition of parking lights fuse F14 (7.5A)
Replace it if necessary.

Act upon the parking lights control and check that state parking lights information ET257 is
ACTIVE, if not, refer to the corresponding chapter of these state.

Check the continuity of the connection:
Parking lights fuse F14 (7.5A) rear and front parking lights
Fix if necessary.

ALP 3

Parking lights not working

Check the system operation

AFTER REPAIRING

87

ELECTRICAL ASSISANCE EQUIPEMENT

87 - 30

Diagnostic – Damage location algorithm

ALP 4

Windscreen wiper low speed not working

RECOMMENDATIONS

No failure must present or memorized

Check the condition of windscreen wiper fuse F07 (20A)
Replace the fuse if necessary.

Check supply +12 volts after contact at pin A7 windscreen wiper switch
Fix if necessary

Ensure the continuity and insulation of the connections:
Wiper switch pin A3 pin 4 windscreen wiper motor
Mass pin 1 windscreen wiper motor
Fix if necessary.
Check the motor operation

Check that windscreen wiper motor or mechanism is free of gripping from mechanical point of view.
Fix if necessary.

Perform again a system diagnostic
Repair the other possible failures
Erase the memorized failures.

AFTER REPAIRING

87

ELECTRICAL ASSISANCE EQUIPEMENT

87 - 31

Diagnostic – Damage location algorithm

ALP 5

Windscreen wiper high speed not working

RECOMMENDATION

No failure must present or memorized

Check the condition of windscreen wiper fuse F07 (20A)
Replace the fuse if necessary.

Check supply +12 volts after contact at pin A7 windscreen wiper switch
Fix if necessary

Ensure the continuity and insulation of the connections:

Wiper switch pin A2 pin 5 windscreen wiper motor
mass pin 1 windscreen wiper motor

Fix if necessary.
Check the motor operation

Check that windscreen wiper motor or mechanism are free of gripping from mechanical
point of view.
Fix if necessary.

Perform again a system diagnostic
Repair the other possible failures
Erase the memorized failures.

AFTER REPAIRING