Chery Tiggo 5 (T21). Service manual — part 505
47–
36
47
Rear Door Protector Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear left door inside handle assembly.
a. Using a screwdriver wrapped with protective tape, pry
up the rear door inside handle screw cover (1).
b. Remove the fixing screw (2) from the rear door inside
handle assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
4. Remove the rear left door assist grip cover.
a. Using a screwdriver wrapped with protective tape, pry
up the claws on rear door assist grip cover, and
remove the rear left door assist grip cover.
5. Remove the rear left door power glass regulator switch assembly (
).
6. Remove the rear left door protector assembly.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing rear door protector assembly.
Avoid damage to rear door protector surface when removing rear door protector assembly.
2
1
RT21470540
RT21470550
47–
37
47
a. Remove 2 fixing screws from the rear door assist grip
assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
b. Using an interior crow plate, pry off the clips from the
rear door protector assembly, and remove the rear
door protector assembly in the direction of arrow as
shown in the illustration.
c. Disengage the rear door inside handle cable (arrow)
from the slot.
d. Remove the rear left door protector assembly.
RT21470560
RT21470570
RT21470580
47–
38
47
7. Remove the rear left door inside handle assembly.
a. Remove the fixing screw (arrow) from the rear door
inside handle assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
b. Using a screwdriver wrapped with protective tape, pry
up the claws on rear door inside handle assembly.
c. Remove the rear door inside handle assembly from
the rear door protector assembly.
8. Remove the rear door assist grip assembly.
a. Remove 4 fixing screws (arrow) from the rear door
assist grip assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
b. Remove the rear door assist grip assembly from the
rear door protector assembly.
Installation
Installation is in the reverse order of removal.
RT21470590
RT21470600
RT21470610
CAUTION
Make sure damaged clips are replaced and rear door protector assembly is installed in place when
installing rear door protector assembly.
Make sure inside handle assembly can operate properly after installing rear door protector assembly.
47–
39
47
Rear Door Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear left door trim board garnish.
a. Using a screwdriver wrapped with protective tape, pry
up the claws on rear door trim board garnish.
b. Remove the rear left door trim board garnish.
4. Remove the rear left door trim board assembly.
a. Using a screwdriver wrapped with protective tape, pry
up the clips on rear door trim board assembly.
b. Remove the rear left door trim board assembly.
WARNING
When removing rear door assembly, an assistant is needed to hold rear door to prevent rear door from
dropping to cause accidents during operation.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing rear door assembly,.
Try to prevent body paint surface from being scratched when removing rear door assembly.
RT21470641
RT21470642
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст